วีดีโอ

Wrong choice there is 2 companies making direct fit powerful servos I got the key fulcrum one and it’s awesome

Hello, do you feel the vibrations a lot with this machine please? I have very sensitive wrists Thank’s

I wanted some of these. Im looking at 25 year old duratrax maximum mt tires on my 1/8th stampede right now. (3rd set in 12 years and were all bought in 1999) Its my daily driver. They used to make great tires back in the day. Now even automobile tires are set to self-destruct after a few years no matter how much tread is left. Might get some hatchets for my daughters pede being brushed. Shame, they look great.

Why are all these comments hatin?

Thank you. Took me like 30 seconds to fix because of your video.

Dude I built a 6s slash with a castle motor, idk to be young and dumb ig but did you ever figure out a way to stop the slipper clutch from always getting loose I’m geared right I noticed you have a different driveshaft in that is that gonna do it or what’s up I just run a 4S it’s 8000mah for the big battery tho so like I hit the gas more than half way all 4 tires burn on pavement and you do that once or twice the things loose again

Are these 2.8 tires

Silicone ear plugs in the centre diff, thicker fluid in the rear than the front provides a good balance.

Them’re wet leaves.

If only it had chest and waist straps, Echo should do better.

its because it's planetary diffs, they spin the grease out and then it leaks out the cracks eventually, plus they use not the best kind from factory, once the trans heats up the grease inside gets thrown away from the gears inside from spinning force and that makes your truck act bad (this is just what i think, i dunno anything about this stuff honestly) i just pay the 100$ and get a 272R, you could mount a weed eater motor on your rustler with the 272R

3 years later what’s your opinion now?

Dude, your camera guy sucks. I had to stop watching about 2 minutes in cause I was getting a headache and motion sickness.

Dude your going to blow that one up to pinning it on concrete and grass like that 😬

Not sure if you're aware, but the reason it's bouncing is because you have your springs loaded so much. put heavier, shock oil, and take out a lot of the preload in your springs. That's why it's bouncing your suspension arms should be level horizontally. If the car is set up properly I have quite a few of these cars.

Hi L and R could be inverted to use as mid motor ? Thanks

How much to take the pump off and send it to me?

Are your gears plastic or metal?

Perfect that was it ....thank you

Thx, I just ordered this product because my slash has unlocked diffs and it’s getting annoying

Do you still have it? How has it held up?

Hi how did you know what belt size to get?

The tall grass or weeds need to be mulched. Just do the same but start on the top of the weeds/grass and chop it all up. By the time you get to the bottom it’s all mulch

The squeaking sound is to driveshaft spray a little WD-40 and the joint of the driveshaft and the squeaking will be gone. I had the same issue just saying 😊

I have exactly the same case. My car is brand new. I haven't driven it for 5 minutes and the red light came on. Does this help?

The littlest of pebbles will chew those exposed gears

There’s a dowel on the lil gear on the main gear rod that breaks inside the transmission

Wltoys rocks for how much less it is crazy how good it did great comparison vid bro

Recently bought an Echo Pas-2620 and a couple of attachments and I absolutely love it, but my only complaint was the handle to me it feels way to flimsy, I took it off and replaced it with a Srm-266 handle.

I need urgent help, connect my Esc to the top port of the Receiver, in the RPM zone and the one that follows, since I did that now when I connect my Esc to the bottom connectors it no longer turns on at all, it's as if There was no signal, and when I plug it into the RPM connector it turns on a permanent red light but not pairing does anything, I press buttons and nothing PLEASE HELP MEEEEEEE

How does an esc have more power?

i like how you organized the screws! i take out screws from a specific area and wrap in small piece of paper w/ note

What is your gearing setup ?

Did you plug it as well or just delete the pully? This so far seems like the easiest delete? And any updates on this before i just do it? Haha

Are catalytic converters necessary after the delete?

Would this work for a 2008 Ford E450 van?

What happened to the blower test😢

You should see the Redmax ebz 9000!

After one year it's buy one get one free. But you have to ship the battery back which is half the price almost of one battery.

Beautiful! Just Beautiful!

I would have double cut that personally. Less stress on the deck and better clipping mulching. That lawn probably died out or came close to it.

Wow das is ja mal eine Intensivreinigung eines Filters 😎

have the 3020T and I have to run .130 line just to keep the thing pulling and not revving to the moon. .105 is nothing for it to pull. super strong trimmer. these things go through tall brush like nothing

Hair dryer for drying..... why haven't I tried that???? My wife would kill me, that's why 😆 I use leaf blower outside which is major overkill...Walmart or Amazon has cheap hair dryers... great video man

I can't get it out of the body

Just wondering if the solution holds up well after 3yr? :)

You had me at Gretta but lost me on the crocs and the Justin Bieber haircut! Keep doing your thing man

Fantastic demonstration. Thank you 🙏

how about TSM when we changed the serwo to not traxxas brand?

Right to the point , thanks for the great info