วีดีโอ

so like you installed the flow switch after the pump???

Is this flow switch the longer or short version

Thats great, but how to install it would be helpful. I can't see into the hole where the drain valve comes out, so im not able to fix it.

Thanks for making this, i had the valve start leaking, so got the exact parts from my dealer, he did loan me the primer and glue . I was debating on installing the 1/4 turn new valve in first, but i wasnt sure how fast this would set up. It would have been fine to align it where i wanted. I chamfered the clear hose slight to fit a bit easier into the old pipe. Just going to wait till tomorrow to start filling, Hoping i have it done, i was losing around 3/4 of water each day out of tub, it was leaking at the bottom of the fitting so was hard to see.

Where do you get the o-rings (in general)?

This was incredibly helpful. You rock, thank you!

Thanks!!

I found the video very helpful and successfully changed my control panel. very happy, thank you

Where can I buy this exact retaining ring? I've been looking everywhere and can't find it.

Hi, We just received a Leep 590 and will be doing our first fill. The manual talks about opening the air bleed value but near the end of this video you mention filling the hot tub through the filter and that by doing so it will bleed the system of air bubbles. So if I do this, do I have to open the air bleed value first?

Thanks very much. Should this troubleshooting be done while hot tub is running, or do we switch off at breaker ?

Give him a break folks. He actually was very informative. Just pay attention. :)

This did the trick. Thank you. After messing about with loosening pipes on the ends of pumps, which didn.t work, you had the correct solution.

André! This is great. My tub is super clean thanks to this!

You talk too much you didn't even show what you were talking about

Thanks, I was struggling to work out how to drain my hot tub. Thought there was something that screwed into the valve, but turns out I just needed to unscrew the outer part whilst holding the inner piece still from turning with a flat bladed screwdriver

this is exactly what i was looking for. thank you so much !

Good advice on leaving one side of the heater open to burp the air out after the new element is in.

Very good and clear explanation!... thanks!

This video got me all jazzed up to hit my Marquis Rendezvous for a 30 min session!

You spent the video talking instead of doing. Do better.

Exactly the information I was looking for. I will be calling you tomorrow. I am tired of replacing poor quality flow switches.

Lead in and subscript on first frames say this video is for replacing a recirculation pump, which this video is not about. Recirc pumps don't have the valve shut-offs usually so different techniques apply. Not the same at all.

Introducing to the right side am I right to assume 3/4" liquidtight up to the hot tub wall? Can you show me how the liquidtight flexible above ground conduit attaches to the hot tub? Then after that how long do the THWN wires have to be?

Pro Tip - Semolina floor is a super great alternative to the corn meal. :)

This video helped me so much ! Thank you

What thread is the barb adapter beneath the pump? Mine snapped in half

How do you replace the whole thing? Mine is leaking from the bottom

Thank you for taking the time to share this information.

Nice thorough instructions.

Exactly what I needed to know. Thanks!

I did this conversation I used the 1 amp switch still getting fl code everything works but heater

My drain valve just started a very slow leak about a week ago. I guess I have to drain the tub to make this repair... I too would like to know how to get the existing valve off of the pipe. Do you happen to have the OD and ID measurements of the existing drain pipe? I can't measure the pipe until the valve is off.

😌 𝓹𝓻𝓸𝓶𝓸𝓼𝓶

Thanks sooooo much❤

thank you for the video

How do you get the old valve off? Cut the hose?

Great vid !

Good idea those little video maintenance. Learn something today.

good video thanks

Thank you for your videos that you post on TH-cam they are very amazing and very educational

Thanks for this video. Very helpful, as was your previous one on start up. Please consider doing more. By far and away, the best content I have seen on Beachcomber hot tubs and products.

We just bought a 750 , in excellent condition it's a 2004 Black 10 person...we will need support & supply's, and will be trying it out this winter, for our needs after trying this one out we will be selling it we want a smaller tub max 6 or a 4 , lol room is no problem on 40 acres,please send us some information and or catalog of you're excellent products.

Thank you for posting. Great information!