วีดีโอ

@@nikotafeby Crashpad stealth

@mitchellwhitley3823 If you exit via Anna Bay, there's a service station on the way back to Williamtown I go to. Has a good underbody washer there. Normally do that then give it a good rinse when I get home filling the chassis with water to flush any sand/salt water out. Been on there many times and always give it a good clean afterwards with no issues

@@gettindirty4x4adventure right on, thanks for tip!

@@jackwieczoreck6786 have a video down the list. Installed a 3 core alloy off ebay.

@user-qt1yj3vu7p Haven't touched them but they do need to be done soon

@@XeGhia351 You own the national park and state forest?

@@gettindirty4x4adventure it’s a joke don’t take me seriously but yeah the Watto’s are at the back of our property. Over 60 years. Not many of us original locals left. I used to do motorcycle tours up there and out to yengo. I like your video. The track you mentioned with the gate now closing it is the top of slippery rock..but that’s not the original slippery rock it’s just to the south of there.

@Abfs900 What did you want to see? It's the same as removing it. Just follow the removal steps and that's that's how it's done. - Plug the water sensor back together - Put the filter in the housing - Tighten the two 14mm nuts - Put the fuel lines back in - Start priming the filter till hard - Start the vehicle then you may need to prime it again until it will stay running.

@@CoreyRichardson1 fulcrum struts with lovells HD coils in the front and 2" shackles in the rear on Factory leafs. Tyres are a 33" falken wildpeak MT

@TheMarcosdeo 4H 1st gear I believe

@robertwilson1827 No. He went around the left, I went the right side of it and it pulled the front wheel in.

@pJ09_90 Nah didn't film it when i changed mine. There's a few on TH-cam I found. It's just two Allen head bolts holding it to the back of the fuel pump. About a 30 minute job

Same track i got stuck. The carpet has to come out and cleaned underneath properly. A vacuum won't get it all out unfortunately

@gettindirty4x4adventure no it won't get itball out but the bissell is pretty good at lifting the dirt and helping dry the carpet out. There was a 2nd spot where he was struggling, you drove it first.

Yeah that was Mackenzie track, I shat myself abit after the wheel lift and panicked 😂

@DylanMoore-o8t thought it may have been. I did it in Jan as part of the Pajamboree (Pajero meet). The wheel lift coming up the hill near the end got me but over all it was a very fun drive. Looks like it has been chewed out quote a bit since Jan.

@@OnCountryWithMick yeah I’m keen to give it a crack going back up the hill, the ranger loves to lift a front wheel so should be interesting

Goes good

Ok good l will get one to l have a 2012 triton 2.5 diesel.and want to get a few things for it like lift kit. Long range tank .

Yes the same car. Only fits the 131kw 4D56U as the 100kw is a different dump pipe off the turbo

www.ebay.com.au/itm/404176458361?itmmeta=01HZ4TDR1NAJ522NJQE2KSZ2PM&hash=item5e1acb5279:g:L70AAOSw3IBj-Cco&itmprp=enc%3AAQAJAAAA0G0nO51vDG59rTQc0hbGNePiPFVBWAMNtutSWnjfR7sHbExOtNv5wyJJ5bvcWvEGWxqsm9vRcZJh%2BkYxWCMwL2SfLt%2FbrwNRXN0G7AomQjJpJfnR%2BwFGcB6sC%2BtDlOGrCctOzZ4Lg4psqw7nPCYn8MwU%2B97C%2FP26TURtiVa6%2BbpCfsk%2FscCznvORwTLmE%2BcdXp65bMaLy8pwFAt26sslADtimRSlt3YyyTUI5Ut4WK8tioBpws3CxOLVimfinRj%2B8DhqburdCPlNFb5hIGfECRM%3D%7Ctkp%3ABlBMUPKAt5r5Yw

That was the day after I cleaned it. Was a mess! The next day after that was the first day at the new job and its been vaccumed once since. Had a decent pile of dirt in the footwell now

You need none of that for this road. Normal gravel road a 2WD commodore can drive everyday.

Heaps of people have it like that and beats me how they get away with it. Mine was in the factory spot out the back and got done twice for it yet there's much louder 4wds out there blowing smoke and racing around.. a snorkel does help a little. Some say it doesn't but you get slightly cooler air then under a bonnet. They'll still defect you if they want. Can't have a vehicle that's not factory without having issues nowadays

Yes

Yep Ourimbah👌

If you didn't notice, I wasn't very pleased.. some people just don't care!

@@gettindirty4x4adventure yeah don't blame you mate. Especially with the fire.

Pretty good

Appreciate it

Ok thanks for the comment. Stated as a DIY video of how I do it on my own personal vehicle not how everyone else should do it on there's. How I did it here is the quickest and easiest way for my vehicle. Can you tell me how it has lots of repetition? Each step is listed and shown from how to remove the filter to how removing it off the housing then installing it back into the vehicle. I'm sorry you can't recommend this video. With 7,100 views and 24 likes, this is the first negative comment I've received on this particular video. Thanks for watching and be sure to like & subscribe👍

That requires the covers to be removed. Put the two wires into black plug. If it works they are correct. If not switch them around. Ones signal and ones an earth. Easy to sort out once they are wired/plugged in into the headunit

​@@gettindirty4x4adventure have you got somewhere i can dm you, how many wires did you already have in that black plug ? 3 or 4? i have 3, that black plug is 6 wires in total it can have

@jasonel-khoury9814 Have a read of this one. Has a couple photos etc showing it all. www.newtriton.net/phpbb/viewtopic.php?t=10531&start=100

Changed it. Must clicked the wrong link when posting the video.

It was bent from hitting a tree

No used tray off marketplace. Buy a ML tub if you want short

Oh that sounds like a nice ute. Takes up a fair bit of room with the hard cover but what I do like is what was in the box up from is now in the draws so no more reaching in. Still need to put the sides on (sold the previous draws) so when I do that I may make up a false floor and maybe have it for a blow up bed if I don't have the swag etc.

Slightly touching on the inner bottom corner of the flap. I'll cut it and see how it goes. Still need to flex it to see what it really hits when it tucks

You can fit 265/75r16 muddies on stock suspension mate no rubbing no issues. That's what I've been running on my one. I have a 2015 mn done about 256,000km now

Yes very crap paint on all white MN's. Have various spots coming off in the normal spots. Yeah 265/75/16 on a 16x8 +20 is the limit for a non lift one.

@chestogaming51 Yes true. Ran that size before the lift. No issues beside slight scrub on the inner plastic till it wore a hole in it and was fine then

I've got the 2014 MN and paint seems good. No flaking and its not thin anywhere. Maybe they fixed that in the later model?

@tublife4x469 Maybe. Mines a MY11 and seems to be the ones most effected.

She's no silver MN from over west but still does the job getting me out exploring tracks👌

your the traitor of tritoneers, get ur arse back in a triton😆

Helped with both I found