วีดีโอ

Can the clear plastic strip that moves the louvers up and down be replaced. Mine has broken in a few places. It is under the white bar that covers it and holds the slats together? If this can be fixed do you have a video showing how?

Sounds good, unfortunately my shudders have no hole with screw to tighten up???

Thank you so very much for your very helpful video! It took me 10 seconds to fix my shutter! Thank you again! 😊

But mine won’t even work with tightening the screws 😒

Totally agree. I installed remote power shades so I could access them remotely!

Bro I hate these damn blinds

hello，I want to know the size of the charging port, can you tell me?

Please could you show how to put the replacement battery wand (that you have shown) into An Older power rise blind. It is replacing my old wand that no longer works and they don’t make it anymore. I received the parts for this from Hunter Douglas but I can’t figure out how to connect them To my head rail. Thanks.

Thank you!

beautiful. what manufacturer makes your motorized screens?

Thank You!!

EXCELLENT VIDEO. Extremely useful video with attention to details. Until finding this video I had been very frustrated trying to reprogram my shades. Other videos failed to mention that depressing the manual control for too long could begin a limit programming sequence. After spending over an hour of trying to program 4 shades using instructions from other videos, I found this one and programmed all 4 in less than two minutes! Thanks so much!

Homies chasing his dream and this is how you respond😢

Ahhh so its queer proof nice

your glasses vrs turboflex glasses

BAD TUTORIAL. Moves way too fast. Slow her down. Im trying to figure out what button to push but he is already gone two steps ahead. Camera could highlight the exact location of button needed to be pushed. This is a POOR demo.

Do this without pretending to run and pulling the impact.

Now do this while carrying a sword and ill buy it (i dont have a house)

HOLD MY BEER LOL

What if one of the slat is broken and needs replacement?

Thanks.... Great video!!!!

Didn't have instrutions on the hardest part...getting the battery pack back in!

Thank you so very, very much!!! Now all of our louvers are good to go, and like brand new. Seriously, thank you!!!

Thank you for doing this video so much appreciated!

After loading 3 sets of new batteries in my battery packs on my shades and remotes, I found your video. Fixed both my bedroom shades in 5 minutes. THANK You! Saved me the 200.00 PLUS dollars I spent last time on my living room shades.

Thanks, it worked. The remote will continue to blink for a minute or so after programming. Just let it sit and it will go back to normal.

The instructions are way to fast and are terrible. Tried several times with no success. Why do you not have trouble shooting list or someone to call.

Tried different coins. Nothing worked except for a flat washer.

The local button works for open on this shade now , how do I fix?

Mine doesn’t have screws. The only screws are where the board that divides the sections is. Any advice?

Thank you so much man! Worked for me :)

And if it doesn’t ?

it’s not doing the jig!!

What a ridiculous procedure. It should be possible just from the remote itself without clambering up a ladder for EACH shade!

My shade did not move after the reset

Omg this worked for me thanks, I was getting close to ripping it off 😂

Thank you. Easy fix, 12 AA batteries.

How to tighten the lever if the side screws don’t tighten anymore???

Thank for the great Video, so much for the old "righty tighty" rule for screwing and unscrewing.

I do this but after a week it gets loose again

The back of the battery pack does not open with a coin, screwdriver, or anything else. Now the groove is ruined. I guess I will just have to do without. :(

To need a screwdriver 🪛 it’s really bad design. But thanks to you I could finally open it.

This video was very helpful. One thing I would add is that after programming the remote, make sure that you change the channel on the remote to whichever channel you programmed the blind. I programmed mine to channel 1, and it wasn't working till I realized the remote was on channels 2 and 5. You click on the number buttons to turn off the other channels and to turn on the one you need.

I did this and the shade didn’t move. I also changed the batteries in the wand so it’s not that either. Any other ideas?

Absolutely amazing that they would have you turn it clockwise to open it, wow, who decided that?

Thanks for the instructions, I liked and subscribed!!!

one slat won't stay shut

There is no open button on the remote.

Thanks so much for this very helpful video Casey!!😇

what if ONE louver is out of whack