วีดีโอ

Thieves removed this switch to get to the ignition wires to try to steal my van until they were interrupted

Nice video 😊 thnx a lot

Thanks so much this will save me a lot of money !

It wowunt muwuv

No one likes u

why does the hazard warnig lights dont work with ingnition off

2018 Fiesta: Its a lot easier on our 2018 car. With handbrake on you only need to remove the boot around the lever nothing else. Pull up in the middle and tabs on the front and rear should disengage. No need to remove the boot fully, just turn 90 degrees so its out of the way. Put car in gear and or chock the wheels. Release the hand brake as far as possible but still able to get a 13mm socket or a box/tube spanner on the adjuster. You might need a deep socket but a regular on a short extension just worked for us. Make a few turns and recheck the throw on the handbrake. Dont tighten it too hard with the hand brake on. Yes it was a 13mm lock nut, not 10mm.

I tried this.... it doesn't work in the real word. my egr was stuck closed best to leave it that way and replace. I ended replacing the egr myself and tbh it wasn't that bad. I'm happy to help anyone whos stuck!

I have a 2012 Ford fiesta 1.2 petrol , looks like the exact same as the one in the video but In mine the valve is different and doesn’t seem to be removable any advice ?

Thanks for your video. Do they need a small amount of threadlocker when you put them back in? It looks like something is on the bolt or is that just wear thanks Ian

Thanks excellent

Take it off and do it properly.

Very good 👍

What tool did u use can't get my one off

Hi there mate do you repair mk7 transit I need a few sensors replaced if you could help me out do you have a garage or number I could contact you on please

Have my like you wonderful being 👍

Brilliant video. Best one i've seen on an oil change. Great pics and explained with detail and simplicity. Thanks.

where is PCV valf in 2012 Ford Fiesta 1.4 gasoline/LPG ? i can't find it

Thank u for information

How to take off the lens?

Helpfull video, thanks!

Cheers for making video just looking at buying a zafira that is blowing on the flexi pipe, I always like to do research so this is very helpful video 👍

Where is the water draining to though? 😊

Thanks/Greetings from Poland!!!

Ok what is the right temperature it should be

Hi What if the readings shows 1 on any Oms setting?

Where is at fiesta ST 2014 ? Anyone?

Hi I have ford fiesta 2010 model jist worried if my radiator coolant fan is working or not ..i turned on my engine and checked its not turning on any idea how can i check that?

I've got a mk2 C-Max with the 1.6L Duratec Ti-VCT engine, which looks exactly the same, same inlet manifold and PCV valve/hose location etc. However, I cannot whatsoever get my hand through that gap. I have quite large hands, but not massive; I'm only 5'8". Is the gap bigger on this engine? Any tips on gaining access without removing major parts? Cheers, great video though

Thanks!

Hi Sir, Very clear instructions demonstrated by you. Thank you for that.

What fuse or relay is for the wipers and windows. Thanks!

What good is it if it can only be done when the engine is off? 🤣

Thanks, have an issue with the marker lights working randomly

buymeacoffee.com/cliveuky

I've got the 2011 Corsa 1.0 and I've currently got a P0107 fault code for the MAP sensor which when I've replaced makes the engine run terribly/not at all. I've been told that the EGR valve could be causing the actual problem. Have you got any experience/advice/thoughts on my scenario? Great video regardless

I've tried 2 new motors and a 2nd hand one now, get no power to them however if I plug my original one in you can here the motor. Think there's an issue with my connector

this video was very helpful, i would like to donate £10,000 for this brilliant video

Hey Mate, Thanks a lot for this fantastic video - That is how they need to be.

Hello van you tell md the problem you had. My fan stays in all the time Evan with mo keys. In the van only way is to pull fuse out .to stop it .thanks

Thanks for the heads up on how to do this . Much appreciated.

Very helpful, thank you

Does the drain plug stay in? I have turned anti clockwise but the flow is very slow and the drain plug just keeps spinning?

This is. Ot a valet key because it can't start the car

Big Thx !!!!

I can't thank you enough, I have subscribed liked the video....my van wouldn't start unless jump started by pushing ...watched your video and walla the egr was stuck a bit of ew40 and I'm back at work...will take a day off now just to clean the whole manifold...Thank you a million times

That would be a really awkward sod to replace 😕

My front washer is ok.the rear one isn't???

Thanks for posting. was very helpful.

This doesn’t work for basic multimeters it would seem