วีดีโอ

So you did a crap nitrogen test and a crap vacuum. Good job

I hope you put some clear silicon around your new light. Just to be on the safe side from leaking water into your headliner.

That filter dryer welding 🔥🔥🔥

You anywhere near Ohio if so I’ll buy it

Lmao 😂

Ayo, audio/editing on your videos is gettinf better 🔥 nice back lights bro

Attics suck bro, what did it end up being?

Easy money

🔥🔥🔥

Hell ya easy money 🔥

I knew a guy who stocked up on engine oil back in 2020 when a autozone gpt lotted on his block lol.

Badass🇲🇽🫡

I’m a big supporter bro can you take me with you one day

Sheesh 🔥🔥🔥🔥

Work hard, play hard 🔥🔥

😮

This is why I always check I work in an industrial setting and you’d be surprised what I have seen. Just recently had to fix 4 fans being tapped into 60 amp fuses that is a disconnect for a 250 foot 60 inch wide chain driven belt. The wires started to short out in the wire nut and melted all the insulation back to the disconnect absolutely stunning. Also know a guy who recently was killed in zues because someone by passed a main disconnect and he wasn’t aware moral of the story here is people do sh*t like this all the time so you can’t be too safe!

This goes hard 🔥🔥

🔥🔥

Please call an eletrican sooner next time

Good job being careful man could’ve seen a very different set of posts if you hadn’t

Fk that's scary

Dang

😂😂😂I love this!!!!!😂😂😂😂

Synthetic? Bad product.

Holy shit

A comment for the algorithm

A comment for the algorithm

Those timers give out so easily

Haha fix one screw another one up. That way they call u back out . My boy

Megger motor for 100%sure👌

Ma boy using Yeezys on the job?!

Welcome back big bro 💪💪

A comment for the algorithm 😊

Very cool

That’s a top celcius flavor right there

Nice...i got a 2.5" level, and LT 295/70/18 falken wildpeak at3ws , puts me anbout 4.5" higher up front, and 2" out back with the tires bigger diameter, get so many remarks about the stance 😊

They could've replaced the coil by the time they called 6 or 7 different companies out there

5 hours? I can replace the shaft and bearings in under an hour.

Will this take out moisture, debris...and so on?

Hvac

What a coincidence, I just did a 1/3 hp on a Heatcraft this morning.

What you mean when you put won’t me with the backup camera? Is the camera using the same wiring as this?

I get it that unit is probably old asf but why you pouring the oil on it? You already know the cap failed 😂

Yep. Caps fail.

Let's go!!!

I’ve had three of those umbrellas they’re straight 🗑️. Last one blew away almost poked my eye SMH 🤷🏽‍♂️

I tested two separate stators and didn’t get a reading from Black and black and red and one was new.

I live in Philly and I started out making 20 a hr being an installer .. Left that field now I’m a building engineer making 32 hr .. I only been in hvac for 3 years now

What grey paint did you use on the 2003?