rick mango
rick mango
  • 1
  • 246 256
Chevrolet Colorado, GMC Canyon, H3 ECT Coolant Sensor
I replace the Coolant Sensor, Radiator, Water Pump and Thermostat on the Chevrolet Colorado. The reason why I replace everything because my temperature gauge reads 3/4 and it still does.
มุมมอง: 246 295

วีดีโอ

ความคิดเห็น

  • @904Hurricane
    @904Hurricane 3 หลายเดือนก่อน

    Your thermostat will be in there, good luck ! 😂😂

  • @kevindavis1219
    @kevindavis1219 6 หลายเดือนก่อน

    Short and to the point. Thank you. By the way I’ve always called the tool a crows foot. Thank you!

  • @a.b.1644
    @a.b.1644 11 หลายเดือนก่อน

    What wrench do I need to change the ect sensor for a chevy colorado 2017?

  • @truthistreason4292
    @truthistreason4292 ปีที่แล้ว

    Man . Thanks..wish every one showed it like that

  • @ronnieyoung7510
    @ronnieyoung7510 ปีที่แล้ว

    The factory should have had that truck shoved up their ass

  • @TheBlank1Ne
    @TheBlank1Ne ปีที่แล้ว

    Heat shield on in rhe way can get back in

  • @elvisramos4050
    @elvisramos4050 ปีที่แล้ว

    Can't see the video correct

  • @oclaothug69
    @oclaothug69 2 ปีที่แล้ว

    It would of been better if you actually show how you did it ☺️

  • @sergiocastro588
    @sergiocastro588 2 ปีที่แล้ว

    My temp sensor doesn’t move from cold… do you think this is the reason ? It’s a colorado 3.5

  • @grifflezloco1531
    @grifflezloco1531 2 ปีที่แล้ว

    This 2 minute video taught everything I needed I was too lazy to watch the long one good job quick work my dude

  • @mikesmobilemecanic9572
    @mikesmobilemecanic9572 3 ปีที่แล้ว

    Thermostat is tricky to get to... i just twisted mine off to do a system flush...

  • @Y_N_K_888
    @Y_N_K_888 3 ปีที่แล้ว

    Thanks. My 06 colorado dies on a cold start when its 40°F or less. I've heard unplugging the sensor tricks the truck into thinking its -40° but Idk about all that shit. Id rather replace. Thanks guy

  • @taylorwells1401
    @taylorwells1401 4 ปีที่แล้ว

    Did the dash on your chevy Calorado say severe temp and that's why you had to change it?????

  • @boxyguy3681
    @boxyguy3681 4 ปีที่แล้ว

    Very helpful. A few More TH-cam videos and I should know how to do it.

  • @hib32
    @hib32 5 ปีที่แล้ว

    if my gauge just stopped reading, do I have to change that sensor?

  • @starvnny3535
    @starvnny3535 5 ปีที่แล้ว

    Thank You Big Time!!!!

  • @DylanFahey
    @DylanFahey 6 ปีที่แล้ว

    What fixed my sons Colorado was the thermostat replacement. That damn thermostat and housing fixed it.

  • @maurolopez8994
    @maurolopez8994 6 ปีที่แล้ว

    Trying to change coolant temp sensor on 2012 Chevy Colorado. Have proper tool good socket but it will not give any. I am afraid to break. Is this put on with Locktie. Any suggestions? It is really hard.

  • @michelekimberling3398
    @michelekimberling3398 6 ปีที่แล้ว

    Thanks for your approach, kept it simple and straight forward, easy to follow instructions without trying to dress it up with technical terms, keeping it real - really helped me out!

  • @tjrayfield5383
    @tjrayfield5383 6 ปีที่แล้ว

    Any1 have a 3.7 liter 5 clyinder motor for sale call me 423.381.7915

  • @miamiSincar
    @miamiSincar 8 ปีที่แล้ว

    i hate this fuckin truck somuch problems no more gm o chevy for me

  • @Deckerd724
    @Deckerd724 9 ปีที่แล้ว

    Thanks for making the vid! It helped a lot. There's a socket that is used for this job. I didn't have a crows foot and nobody in this hemisphere had the socket so I bought one at Sears and modified it.

  • @AstonSubstantive
    @AstonSubstantive 9 ปีที่แล้ว

    Good video- thanks!

  • @ricky23h
    @ricky23h 9 ปีที่แล้ว

    having the same problem on my 08 h3. a/c light onn, Do I replace everything ,sensor ,clutch and thermostat? plz advice.

  • @1peaceraulvideo
    @1peaceraulvideo 9 ปีที่แล้ว

    If you replaced everything then it has to be a bad fan clutch. Its common hummer h3. Had to replace everything radiator, thermostat, sensor and finally fan clutch. I replace the water pump about 3 years but i would advise to replace the fan clutch while you're at it since you have to remove it anyway. They have a tendency to go bad which can damage your radiator, thermostat and sensor ( which is what happened to me).

  • @tadlandin2733
    @tadlandin2733 10 ปีที่แล้ว

    How did you tighten it back on? I bought a similar crowfoot socket/wrench, but it was too thick to do any good. I ended up cutting the old one and using a deepwell socket to get it out. The problem I'm having right now is getting the new one tighter than hand-tight. Any suggestions?

  • @carlospacheco1945
    @carlospacheco1945 10 ปีที่แล้ว

    I changed the thermostat without taking off the tire

  • @elchakas187
    @elchakas187 10 ปีที่แล้ว

    What was the reason u replaced all that? Only asking cause I have a 06 h3 and my temp gauge goes up 3\4 of the way until I start driving again then it goes back down. Just wondering if you experienced anything similar

    • @carlospacheco1945
      @carlospacheco1945 10 ปีที่แล้ว

      I have a 06 colorado 5cil. It was heating up like yours and I replacd thermostat, radiator, fan clutch(put on a severe duty one) and the water pump, qnd it fixed nothing untill I took out the thermostat and broke it and now it runs cook but the gauge dances up and down sometimes , so im gonna replace the swnsor and if it keeps going crazy ima hace to do the heads

    • @walterbarahona1866
      @walterbarahona1866 5 ปีที่แล้ว

      Same proble ar you ready fix?? How you did??

  • @stevesmith8854
    @stevesmith8854 10 ปีที่แล้ว

    Did you ever get the dreaded "A.C. Off" message in the DIC? I understand that a bad coolant temperature sensor can cause that message.

  • @rickmango5706
    @rickmango5706 10 ปีที่แล้ว

    No I did not drain the coolant just a little coolant came out when I removed the sensor. just put a pan under the sensor

  • @rickmango5706
    @rickmango5706 10 ปีที่แล้ว

    No that's how I removed it with that socket. Another way is buy a cheap 15 m m socket and cut it in the middle make it look like the oxygen sensor socket to removed it.

  • @circa371
    @circa371 10 ปีที่แล้ว

    how did you get back there with that wrench really. tight spot. did you have to remove anything else?