- 14
- 17 055
Apoc's Garage
เข้าร่วมเมื่อ 31 ธ.ค. 2022
All things cars and fun.
B8.5 RS5 JHM Downpipes and X-pipe revs sound clip (not to redline)
Stock other than the JHM downpipe and x-pipe. Regular factory exhaust not titanium trim.
มุมมอง: 125
วีดีโอ
B8.5 RS5 JHM Downpipes and X-Pipe Combo Cold Start Comparison | Stock 2013 Audi RS5
มุมมอง 3499 หลายเดือนก่อน
This is a 2013 Audi RS5 (B8.5) non titanium package. Everything on the car is stock except for these exhaust pieces. The extra steam in the second clip is because it just rained and the car was sitting under snow for a few days before recording just extra moisture built up. The new sound is amazing, will have driving audio clips of both uploaded sometime as well. Kit is here: jhmotorsports.com/...
Check 2.0T Engine Timing Chain Stretch with VCDS.
มุมมอง 4.1K10 หลายเดือนก่อน
In this video I show you how to use a vag-com and VCDS to check the timing chain stretch on a 2.0T Audi. This car is a 2013 Audi A5. Written: 1. Warm up engine and leave it running 2. Connect & open vcds 3. Choose select control module 4. Choose the Engine module 5. Give it a second to load and select Advanced Meas. (measuring) Values 6. A window will popup to search for values. Search for "Cam...
Own a 2nd gen Sienna? You NEED to watch this. - How my TOYOTA engine died!
มุมมอง 1.5Kปีที่แล้ว
Here’s what killed my second generation Toyota Sienna engine. And you could save yours by just replacing this cheap and easy part!
Frostburg, MD Cruisin Main Street 2023
มุมมอง 1.1Kปีที่แล้ว
Squeaky brakes were the car in front lol also there was a new Nissan Z behind me I couldn't get on cam sadly.
Van Shoots Flames Over My Head - Miata Top Down Cruise In
มุมมอง 40ปีที่แล้ว
Mildly concerning moment when you're top down and a dude has a flame thrower on the side of this van
Gilpin Hillclimb RS5 Spirited
มุมมอง 50ปีที่แล้ว
Not actually at the event so can't push or cross the yellows. Just went a lil spirited in my RS5 to get some sexy audio and test out the cam setup with race render lol.
2013 B8.5 Audi RS5 Acceleration Sounds Stock
มุมมอง 87ปีที่แล้ว
Microphone is clamped to one of the anchors in the trunk, olympus me51s mic plugged into gopro hero 3. Exhaust sound is beautiful. Not the titanium package.
2013 B8.5 Audi RS5 Downshift Sounds Stock
มุมมอง 282ปีที่แล้ว
Microphone is clamped to one of the anchors in the trunk, olympus me51s mic plugged into gopro hero 3. Exhaust sound is beautiful. Not the titanium package.
Not for measurement on a Nissan Micra??
3MZ-FE Engine. -The Crown Vic sounds like a great idea. Sorry about the coolant brudda
My scanner shows around 6.25 and I just did a timing chain trying to rid of p0016. Matched all link colors with the correct marks and everything lines up perfect. Still get p0016. Checked several different times. No fix. With the adaptation being above 6 does it mean the timing is still off somehow??
Something definitely off still. The chain could be properly aligned but elsewhere is causing the problem. Like if the guides weren’t replaced, tensioner is bad or not reset properly, a gear is slightly off somehow or even the sensor is bad. I’d double check everything beyond just the marks is good
Hello. Is this just the kit? Still stock muffler and middle muffler? Do u have the sport exhaust also?
Mines says minus -6.61 is that good being on minus??
Mine is -1.8 degrees at 60k miles (2018 Audi Q5).
I tried this on my 2018 VW GLI, it shows 3.3* for intake and 47.6* for exhaust....🤔what does that mean..car has 96k miles.
This also works for tdi engines euro 6?
Is it possible to check TDC for camshaft and crankshaft when doing a timing belt replacement
Thank you for the tip just bought a 2005
my 2014 audi a6 with 90k miles is showing -5.3 to -5.9 I guess my chain should be replaced
I just did this test on my MK7 GTI with over 150k miles. My value showed 0.3°. It wasn’t even negative. So I’m assuming my timing chain is in very good condition still am I correct?
Yea think that’s good sign
Why i cant see camshaft? I have vcds 20.4.2
what if I want to check the 3.0 tfsi? should these values be the same? More than 5 is already an exchange ?
If you have this same measuring value I think it would be around the same. But I don't know that the 3.0Ts show this value, I think most if not all do not have the ability to do this
Should I worry about timing chain stretch on a MK7 golf I’ve heard the engine changed and it isn’t a big deal really
Not really something to worry about until 120k - 140k miles since the last timing chain
I have 0.7 inlet and -0.7 outlet am i good?
Get another Sienna. I have 2 gen2. Great vehicles!
Was looking for a video on this is it louder then stock? Hard to tell from vids. How was the install on the NA. Thanks for the vid
Much louder than stock. It’s even louder than the previous smaller air horn the last owner installed. Install is not terrible but there is one bolt I remember being hard to get in with big hands and small clearance
How can you solve it?
Getting a whole new driveshaft is basically the only solution. Flyin Miata has a driveshaft that you can buy for like $350. I’m thinking about doing that
Thanks, this was confirmation enough for me to order a new drive shaft. Hard to find the exact noise but pretty sure my u joints are toast lol
@@Ahelow yeah I got my new driveshaft in and the noise was completely gone. I messed around with the old one after taking it off and it was definitely a worn u joint. It’s been about a month since putting it in and has been completely silent
Sorry I'm late but yea you need a new driveshaft. I suggest buying one with serviceable u-joints so you don't have to replace the whole thing next time.
@@apocsgarage No worries, I replaced the drive shaft and it's all working great now