วีดีโอ

i hv been watching a lot of videos on native vlan, but yours was the one that finally made it click for me Thank you so much.

Thank you!

my set up for everything was completely different but same end result thank you for the info this was causing a lot of issues for my pc because I can't afford to upgrade and pay for it....

hi, can you tell me which simulation you use in this video

The link no longer points to an active page. Can you relink the correct part?

Thank you sir

hello bro, please inform your application simulation

Thank you!!

This is a good scenario.

One side of the switch is in vlan 31 Other side is a management switch ip of different series...what is the commands on either side to turn up the link in RF radio

Gods bless you for this video

no logging console

but i think you need to configure the link as trunk link netween switches?

thank you

thx bro

Mobile guide?

Very simple explanation.. thanks for the content

Awesome information. Thanks!

480p on 2024 ? Srly

damn! this one is really helpful I love it. Thank you so much!

You are the best! Thanks

Thanks brother 🎉🎉🎉🎉

It really worked

Sir I lost my path in system side how It fix

Very very helpful sir ...... Great thanks 🙏

if i have 6 stack switch and 2nd switch has been down than how to find the faulty switch ?

how did you know to use that ping 192.168.1.5?

I have downloaded but I can't find the media features pack.like you installed at the end of the video . Please help me.

Thanks for you. I watch many video 100+. But only You help me. I use Eve-ng. These are my first experiences. You give me solver. "I must connect telnet to port for first conf "

I didn’t get the message on itunes

Thanks for simple, concise, Helpful video😄

It’s not letting me remove S mode it says try again

After pasting back to the switch, how do you save the pasted configuration?

Question: in the startup of the stack...usually there is the config sh run | i provision switch 1 provision xxxx.xxxx.xxx.xxxx switch 2 provision yyy-yyyy-yyyy-yyyy". When you replace the switch 2 dont you need to remove the "switch 2 provision yyy-yyyy-yyyy-yyyy" line and replace it with the new command "switch 2 provision zzzz.zzzz.zzzz.zzzz"? conf t no switch 2 provision yyy-yyyy-yyyy-yyyy switch 2 provision zzzz.zzzz.zzzz.zzzz

There isnt written anywhere that this was a replacement of a single switch in a stack. whatching the video i got confused.Can you please change the title?

ty you so much i try for hours and my f$cking professor he didn't teach us

The SD Card, does stick outside.

tnx bro

But the priority hight value switch should become master right ?

great video thank you

Beautiful!

Don't stop you are awesome🤝

thank you for the tutorial, can you please inform me about the name of the emulator you are using in the video

Very helpful video to understand radius configuration

Thank you so much this is the only video that helped me

Crystal clear, thank you so much !

How can you post tutorial when anyone can see that you have NO IDEA what are you talkind about - HDD can be upgraded-look at SSD-M2 slot / Ram can be upgraded-look at empty Ram socket.

This laptop is a waste of money.

Hello, what hardware have you used here to extend displays to 3 more monitors.

can i write the command #int g2/0/1 for example to access an interface on switch 2 ,or just by using #session 2 command ?