วีดีโอ

No bother 😂😂

Typical audi rust on the wing's the arm rests are terrible for breaking. Bpw Balance shaft breakes and oil pump goes on them. Decent motor for £1000 i like them best of luck to you with her 👍

2 things You can grease the mechanism from the outside without dismantle using spray grease with the thin tube attachment ⚠️ Usual cause of handle not opening door....... The threaded rod slips out of position usually when handle forced during frosty days. The setting that works is when there's 6 threads showing at the top of the linkage rod. We strengthen the white plastic piece with aircraft locking wire. This mod makes them frost proof 👍

Looks like a cracker, E46.....a legend. Convertible not for me.

Nice

Steal at 1600 👌🏻 the alloys are mv1 alloys. Just sold mine for an e60 m sport 😂

In a time where you can be bricked out of your modern car and have to tow it to the dealer for an update just to start it... your car is one in a hundred. Don't ever let anyone tell you anything else. if you plan to keep the car for quite sometime, the manual 5speed and 6 speed zf are very robust. Personally I own a M3 S54 swapped 325i e46 wagon with a 5speed manual trans from a e36 m3. Still wouldn't trade that inline 6 for any n54/55 grenade

Bargain. And the 3 litre. Lovely. Manual for the win if its my m-sport. But i had the auto which is a smooth cruiser that pulls well. Its design is classic as is the e30 and these are on par. Great find and so cheap at that price. Values will rocket on these.

That’s a lot of car for 1600, good buy I would say

Just an update to this. After replacing bithe rear calipers, handbrake motors and a brand new radiator (£££s), the turbo actuator died and it was going to be £1700 just for the part. I sold the car at a loss with the fault disclosed. Obviously, I learned a lesson and future purchases were much more successful*.

If I end up buying one I will have a good look at the bulkhead corners,, I have welded most of the other areas on a few Mk2 Cavs in the past

Tidy car that 😀

Rover 75 and a Mk3 Cavalier, good choice.. I have been looking at getting a Mk3 Cavalier, had a couple back in the day 😊

I now own this car its outside 😂 its now an sri replica lowered 60m

1 reply

Where can i get it and is it possible for Macedonia???

hello Sir how did you remove the sill ?many thanks, regards

Much appreciated great vid especially the vactan tip😊

Great video, 🙏

Nice to hear House Sparrows in the background, you hardly see,or hear them in England now.Regarding the motorcar, looks like you have a "sound" example,hope it runs as good as it looks.I bought a wedgewood blue CDT Connesuier 2ltr diesel,(2001),drives well,but there are some corrosion issues to sort out.Good Luck.

Did it stay leak free without any extra sealant applied?

Hi Bud, are the rear window sill`s both the same on the left and the right? I have found two new ones but they say right rear door. can you help . all the best J

Well waste of 2 minutes

Can someone give a suggestion to swap the inside handle wity new ones without broke the oval chrone surrounding again?

Mine has a 376 im confused and looks nothing like yours

There is another plenum drain on the driver's side up near the bonnet hinge to match the one on the passenger side.

Can’t hear you due to the road and wind noise.

Das war sehr hilfreich. Ich hatte bei meinem 75 100anniversary Wasser im kofferrrsum und habe mir die Dichtung bestellt und gewechselt. Das lösen der Stecker war ein wenig mühsam. Das Video war sehr hilfreich, vielen Dank und schöne Grüße aus Deutschland, nicht traurig sein wegen der Citizens😊

Sorry for the loss of your father nice car I think it is one of the most beautiful audi models ever!

What a beauty!

I am sorry for the loss of your father.

Thats a LOT of car for £1900 😮

Just had mine done, it was black exactly the same as on the video, 185000 miles!!

Mirrors might be just the switch

Now got this in my fleet! Safe to say it’s not looking as good as what it did in this video! 😆

Probably worth amending your video title to Plenum *Drain* . Can't believe you didn't a) unclip the ECU (5 seconds) & lift it out the way so you could clean any soppy crud underneath it, and b) "didnae bother" with the other side. Honestly mate, K-BDG might be a better channel name.

Lovely cavalier mate and with the izuzu engine even better I have a mark 3 astra f 1.7td with the same engine completely original and lovely to see a older diesel on the road

My 2006 1.8 petrol Civic has done 150,000 miles and doesn’t have any issues with the car, although rear axel is now corroded, E10 petrol has knocked out fuel injectors so I only use premium E5 petrol, only wear and tear item was new clutch at 117k Miles These Civic’s are a great car only if they’re looked after

That looks good for an old car.

That plenum guard is made by Jules the Rover 75 Guru of Colwyn Bay

Thanks for the video, looks like I'll be doing this sometime soon 🤦

👍

this car is now parked outside my house lol

Very interesting good information there buddy I dont know i missed this video. 👍

Ah, so it’s normal for water to get down there? Somewhat relieving for me as that tends to suggest the bulkhead can cope with some water. It’s happened twice in the autumn. Presumably it did drain slowly. Will unblock it now.

Lovely

Split_Pin, congratulations on your purchase of a Mercedes SLK R170! Many viewers might be curious about what it's like to own a budget-friendly luxury car like this. Sharing your experience and insights, including the pros and cons, can be helpful to others who might consider a similar purchase. Keep the updates coming, and enjoy your new ride! 🚗🌟 #MercedesSLK #CarOwnership #BudgetLuxury

I like it looks a decent motor. I have never owned a Mercedes yet maybe one day. 👍

Great cars and starting to be appreciated now

Is it really important to disconnect the battery?