วีดีโอ

sungoldpower LFPV 18kw inv/charger failing

Reassembling the cleaned and grease parts into the chassis as well as the spring plates and return spring rebending.

Another switch rebuild in greater detail.

Datsun 240Z turn signal switch refurbish part 2

Making a simple repair to the contacts for better signal. Etc.

Datsun S30 240Z 280Z switch refurbish

I added a 4 in linear actuator to the hood hinge. The OEM torsion bars are still there and only had to make a few mods to make it all work. Safety Hood pin disables the switch from working if the hood is closed. Will not work unless the hood has been popped open. Actuator has Auto stop at top and bottom

Installed it today and took the car for a spin. wanted to check the clarity and sound. So far I like it. Better than the reviews I saw.

I used an 8" linear actuator, an aluminum "L" bar and L brackets to mount it to the hood. I doubled up on the bracket towards the center for strength. Hood pin on the latch shuts the relay down so there's no accidental raising while it's locked down, so no holes in the hood.... I have a switch on the inside center console and another switch by the battery to work it from outside.

The previous design, for lack of a better term, Sucked. So I redesigned the layout and used Super Flux LED's in 4 rows of 12. 2 rows for parking lights and all 4 rows for turn signals. If the parking lights are on, then you only see 2 additional rows light up with each flash. And an FYI... The Headlights are BiXenon 5000K H4's with Acura Ballasts in an H4 7" conversion housing. And I use an EP3...

If you find yourself having to push a little harder on your Turn signal to engage both front and rear Turn Signal lights, because your switch contacts are slightly bent, then this short video should help. This is the non tear down fix and should work in most cases. Worst case scenario is for the T/S to be rebuilt.

I redid the conversion plates on my 240Z. Added LED Reverse lights, and added Sequential turn signals. Made the video so I can stop trying to explain it, and just show it. 240Z LED Rear tail light conversion starts at $300, LED Reverse light plates are $45, Sequential turn signal circuit is an additional $90. 240Z Front marker/turn signal LED conversion is $150. datsun-240z-upgrades.net/ for mo...

This is a follow-up to my LED taillight video. I redesigned the fronts to have 2 rows of 6 for the parking lights and 3 more rows of 8 for a total of 36 LED's per assembly. The old style only had 3 rows of 6, 1 row for PL and all 18 for turn signals. The Conversion is $150 for the set. You send them to me, I polish the lenses, instal the plates, clean the housings and put it all back together a...

Datsun 240Z LED Conversion by DatsunDave09

Datsun 240Z doughnut at airport

Maryhill loop road ZCCW.org 4/26/09

74' Datsun 260Z before winter 09' rebuild

Hatch pop in a 260Z

Honda wiper motor in Datsun 240Z Dry wipe

honda to datsun wiper motor swap

240Z new exhaust

dyno at 6000 rpm

6500 RPM's and held it for 10 seconds on the dyno

My little burn out, heard blocks away.