วีดีโอ

That was the fix. Someone bumped the switch.. thanks so much!!

I ran to my ac unit .. of course it was set to fan on Now its on auto.. THANK YOUUU

How do you get it out of a programmed schedule. Someone messed with it and I can’t get it out

Thanks for the heads up. I did get the 2800 code and was able to reset it with your info

How to take out the t-stat in hold mode

❤

Man thank you so much it works 🎉

We need a new video

Thank you for not playing music over your instructions

I always tell the customer about the defrost cycle of their new heat pump and what to look for. Frost, steam, a loud bang from the reversing valve changing over and condenser fan not running with a buzzing sound is normal. That greatly reduces unnecessary non billable service calls and concerned customers

thank you ! 👍

I just had a Defrost Circuit Board go out because I noticed this under conditions that were above freezing and in dry weather; this is normal in mixed sleet or snow and near freezing. I called for service and the defrost circuit board was out.

If you get 2 to 3 inches or more of ice then guess what? Check defrost mode and put refrigerant gauges on and check charge

It’s stupid to have to manually switch to emergency heat when outdoor gets into teens. You should be able to set a trigger point then let the controller turn it on when temps get below that point.

I just installed 2 Infrared lamps for my Mini Split. Aiming them at the outside coils. No more freezing. 250w each lamp. Spread them evenly over the outside condenser. About 5" away. A small roof over the system might also help. Now good down to 20 deg F. I have not tested it lower.

Thanks for taking the time to help others! It worked for me! 👍👍

Omg we didn't realize you could scroll down on the groups lol.... wasted 2 hrs but this video save us !

And how do you set the compressor lockout?

So does turning on emergency heat to "enable", turn on the Emergency heat, or does it just allow the system to use emergency heat automatically when it calls for it due to low temp, defrost cycle etc? Conversely does putting emergency heat to "disable" prevent the system from automatically using emergency heat when it feels the need, or is that just more of a "auto" setting? Also, if the system is using the emergency coils automatically due to low temps of defrost cycle, etc., will the thermostat tell me?

My control panel melts after 2h usage. Looks like the cooling stoped when I stop the generator after 2h of run. The heat melts the control panel and deformed it. But it looks like everything is working an can boot up and use the buttons. But it wont start anymore im getting 2800

Thanks for the video. It was a very simple fix.

Humid houses have more mold

I'm first forever

helpful video. Can you address how to adjust the balance point between Furnace and Heat Pump on this thermostat? I would like the furnace to kick in a little (+10 degrees outside?) sooner.

Im Freezing how do I turn on emergency heat

Thanks for the explanation. When do I turn it to Emergency heat?

How do I set the dual fuel crossover temperature?

Tcont802as32daa

Wow - so happy to find this video. We are freezing here in this winter storm and your video was very helpful in us accessing out e-heat.

I couldn't even find this in the installer manual. Awesome way to bypass the lockouts that don't seem to work at the set temps.

Thanks

Thank you! Couldn't find this in the installation manual. Wondering where you found this information?

Just had this installed. It's the lays user friendly thermostat I have ever used. The e-heat option literally disabled the compressor from being used. Not just enable e-heat for when it gets cold, but fully disables the compressor all time. Why? I have to put in yet another call to service because of this non user friendly UI.

Thanks for this video. Our generator had not done its weekly self-test in quite a while. After watching your video I found the reset button and noticed that it did not lock in either position but seemed loose. I pulled on it slightly and it came off in my hand. Turns out it was only the rubber cover holding it in place. I then replaced it by folding the rubber cover back over my finger and carefully pushing the switch it until it latched making sure it would stay locked in either position. Replacing the rubber cover proved a bit of a challenge because there's not much of a lip for it to catch on. The generator started fine after the error code was deleted. Thanks again for this straight to the point video.

Thank you for sharing this information. I’ve been wondering WHY my home has been so humid 🤦‍♂️ PROBLEM SOLVED 🙌❤️

Thanks for helpful explanation of why air con goes into defrost mode in winter. Can relocation of outside unit to a more suitable location help? Or is the ambient low temperature the key cause of freezing.?

Mine freeze up to the point the fan scraps the ice. I have to turn it off to defrost a day or 2 and I clean the base to unclog debris and pollen on the screen. I have a jacuzzi 50 000btu model.

This is painful. I just need one setting for the whole week. since I work at home half the time I think its too cold. I wand to bump the min temp to 74 and the max temp to 76,

Question: I have a new one like shown here(close). We had a storm and my ground faults popped. After resetting that I saw Generator had a red light on. Showed elec. wiring error and I re set it to where it shows ready to run and hours of service (time its been standing by). Have all green lights. It keeps flashing from the screen I spoke of to Hours of service and back to the original screen. Do I need to do something else?

this is great info. i have this same thermostat and the TEM6 unit so pretty sure it has this functionality but I don't think my installer has a clue about it. Would you be able to do a video for this for dehumidifier function as well. Is there also something he has to do to the unit? I saw another video that was saying something has to be set up on the control board and/or dip switch - so I don't think me doing just the thermostat settings is going to do any good? Any help you can provide would be sooo appreciated. In Tampa with high humidity and can't seem to keep it below 70% hardly ever. Very frustrating after paying a premium for this unit!

/AnitaF

Fantastic quick and easy Instructions. Thanks for your help

I did not understand either he set up the heating or cooling, I am struggling in setting up cooling.

Can you place it in A/C mode and have it defrost if the reversing valve isn’t working?

Help!!! My system settings are responding. Either is putting up heat everything else works !! I cleaned the screen, replace batteries nothing is working ??

Can a failed or defective Thermo Coil sensor not sending signal to defrost board cause ice build up as well?

5 days and an hour tonight, I finally found your video. The one i needed. GOD BLESS YOU SIR!!!!

Nothings better then a heat call where you have to work and tear apart a unit outside in a blizzard...Heat pumps are a joke, I won't work on them in the winter, they can Heat from the strips because that's so efficient 🤦‍♂️.

It got down to 24 last night and mine iced up on the outside and inside where the coils are. It got down to 55 in my house, I guess that defrost function didn't work for me, so we slept with extra blankets for sure. I also tried emergency heat and the air coming in wasn't warm at all, it dropped the temp two degrees in the house. That unit is only three years old. I guess I'm gonna have to call the installer that put it in to check the control board, good thing is I have a ten year warranty on the parts.