วีดีโอ

Har en 6x6 Can am 450 Xu+, drar ca. 1 tonn tømmer bakpå om vinteren så en "liten" fres frampå burde gå greit (?). Ser ut som den kan ta en del snø også, går litt seint i forhold til brøyteskjær men med fres får man iallefall kasta vekk snøen :) Er det noen andre alternativer du heller ville brukt penger på?

Har du satt på tommel for din om den er fra P.Lindeberg? Sliter med å finne. :)

Hvordan er kohler kontra honda på winter pro? Vet du? :)

Hej, Vi bo off grid. Beroende på sol och (i november/december en elverk. Angående max power-output tycker jag den här maskinen ska vara en mycket bättre val än en "vanlig" hydraulisk maskin. Men jag såg i video beskrivning:.it has its drawbacks.... Betydande: det finns minskar. Vad är de jag undrar? Slitage av drivstången? Hoppas ni hittar tid att svara. Mvh Anthony Vi kör en max 4000watt elverk. 3000watt nominellt

Hvordan sette skovlene i drift?

Finally, I’ve been watching videos about this piece of equipment to decide if I want to purchase one or not, and this is the first one too actually show the real breakout strength with a bucket curl. Every other operator relies on the boom for some reason and it looks uncomfortable bouncing around. But like I suspected all the break breakout strength is in the curl, with the cylinder being the same size as the other’s but with leverage. I have rocky ground and I think I’m sold. Maybe grab a rock thumb, have too dig some deep trenches.

Er den forsynt ifra eit agregat, evt kor stort agregat er i bruk?

Rammy is a much better blower then either Bercomac or yours.

Nice setup for removing snow. What brand of blower do you have

Will the belt of the ATV withstand such slow speeds for a longer period?

This thing sucks , get a real blower.

Hello, I have a suggestion for the problem with the mounting bar wobbling. I would use a square u bolt to hold the bar tight to the atv frame. I did this with my atv snow plow, works great. Thanks for sharing problems with this blower.

Hvor kjøpte du ny elektrisk motor til sving og hva koster den?

Take a piece of a plastic bag and put it over the the hole on the jerry can with an elastic band , it’s not perfect but u won’t have snow go in

Quite the agonizingly slow talker. This whole video should have only taken a few minutes. 👎👎👎👎

Hvor er dette?

nice video. trying buying one. what a waste of time.

How the price for this blower?

This must be a joke, too many machines to d a very little job. Even a self propel snow blower it self or a used atv plow will do a lot better job than this set up.

I would like to have one base to Egypt

Hmm... Så den hold med andre ord ?

Something does not seem right. I have a bercomax snowblower on a lawn tractor "24 hp pto belt driven" and it does not vibrate nearly as much and throws the snow without nearly as much effort. I'm of the impression your auger blade needs to be re-welded if it is no longer attached or there is an issue with your impeller / snowblower. It seems the snow is coming out in chunks instead of a smooth steady stream even if it is slush. I'm very impressed with how much work the snowblower is doing especially in heavy slush but something seems off. I can throw deep snow "not slush" about 30ft smoothly with my bercomax 48" snowblower but need an ATV like you have with 4wd .

rammy is much better and uses much less fuel

Er det noe du ikke liker med denne maskinen? Mvh Alf Einar

Dear project Tillerskogen, Ferry from Indonesia. always success, keep up the good work, God Bless You

Hi from Sussex, New Brunswick, Canada. I see a couple comments that it does not work very good however it works great for a 22/23 up motor. I see expensive John Deere small tractors that do not blow wet snow much better. You were blowing the snow a fair distance in the first part of the video and were travelling at a good speed

Didnt look like it was throwing far

looks like it can barely do the job

I've got the kellfri model had it 2yr9m and last week the boom broken away from the frame not enough steel in the frame luckily after threatening to go on internet about poor workmanship kellfri have agreed to replace the whole chassis under warranty but I have to change everything over. So beware of welds ect. Great little machine otherwise

You got a nice tractor use it

Was going to get one but now what I’ve seen no thanks

Nice setup

Er det mulig og fjerne den dumme beskyttelsen? Dette er den elektriske versjonen?

Very impressive for 550 fan cooled engine. I am looking for a second machine for my wife.

is there a dealer near stroudsburg pa? and how about prices?

I know this is a year ago so maybe you’ll see this, but I’m looking at these now and wonder if the 650 has enough power, or do you wish you’d bought the 1000?

👍👍👍

If you wanna throw the wet stuff better take up the gap between the impeller and the case with some rubber from a mud flap on the end of the impeller. Could you possibly show the electric clutch they use. I have a centrifugal clutch in my homemade one and would like to increase the auger speed

Hate to say it but my homemade one works better. I don't get the snow rolling in the front.

All the video that I watched had 3 inches of snow. This is a Great demonstration. Thank You

th-cam.com/video/n3G_qoC6a0Q/w-d-xo.html different bucket but basically the same,i also have a 24 inch sand bucket,i like the small bucket on yours which makes ripping stumps easier.

Necesito una, para colombia

Tror Lovol traktoren din hadde fungert bedre med rimeligere snøfres fra Wee.no, og sittet varmt og godt i traktoren

Chilly work environment. Good thing that the Can-am is so effective!

Great work,can you adjust the revs of the engine up and down,cheers

Got the winter package.?..or that a mountain of snow in the back..💪♥️

Hei. Hvordan er bruken av denne fresen over tid? Noen svakheter? Har selv en can am 6x6, & vurderer denne opp mot Rammy.

Такой 6х6 я еще не видел))).Заводской?

Ser både bra och kul ut, lite störande med all snö på atv:n bara.

Thanks for this video, it's making the wait for my 6x6 and winter pro easier, should be getting it next week ;) Any tips or tricks, stuff you wish you had known when you got it?