วีดีโอ

I would pull out the fuse and put it back in. It will restart the stereo system.

What tie rods are you running or did you modify the oe ones to fit

Mine does the exact same thing

Just ordered mine...thank you friend.

Hey guys, i was having a very similar problem. I wanted to share that i used an ArmorAll glass wipe on the screen and it temporarily fixes it.

2016 yukon here, and this started recently. I know it's just gonna get worse. These cars were built to break

I just replaced the digitizer today. My truck screen is still having the same issues. I did the best I could lining up the new digitizer on the metal frame, but I'm wondering if I didn't get it on there just right. Could it being misaligned slightly cause the problem to continue? I am about to just disconnect the digitizer and go forward using the buttons without a touch screen.

Today after 2 years of Issues I bought a new Digitizer / Screen off of Ebay . Pulled the trim panel off , a few screw and connectors removed and the radio comes out . About 8 screws , 3 ribbon removals and the old screen is out . Put the new screen in and install in Reverse and its Good as new again . What a MAJOR relief that it works like new again . $55 and an hour of my time is all it cost . You get the whole unit not just the glass , no glueing or any of that

I regret lifting my 1996 k1500 with 4 inch lift. Although it looks great seems like lot of vibration. Should've listened to my dad when he said leave it alone lol! Does look good with 33s and bullet holes though. Anyhow i tend to learn hardway. My trans just blew now. 🤣

Watched your video a year ago as my 2018 Silverado was experiencing almost the same symptoms, it was very annoying..I ordered a replacement screen on EBay for about $20. Swapped it out and everything worked perfectly. It’s been a year now since the change and it’s still working perfectly. Thankyou for your video it was enormously helpful

Would you have to hack the botttom plastic on both sides with a shallow mount double din?

Hi, Mine did the same like yours, I fighted a new Touch Screen to mine and now it works like new once again.

Thank you for that information because my trucks been doing the same thing yours was so I will go to eBay to see if I can find that screen. Thank you for the tips that really helped.

Did this replacement and now I have a blank screen! No backup camera, even! Worse than before! Ugh!

You are the man! Have this same issue and it drives me crazy, thank you for this!

I did put my fist into mine! Damn it. Now I need a new screen!

you got a link for the clear headlights and turn signals the ones i bought didnt look good compared to yours

Hello, I have watched all your TH-cam videos and your video quality is very good. not SEO your channels and videos. For which your video is not getting good views. If you want to get views on your video then you can contact me. Thanks Imran

We had this problem and we called SXM and they walked us thru a reset that fixed the problem .

Not gonna lie bro I ordered some headers from EBay and forgot about the EGR rear pipe also. Shit nice fix no doubt.

What trans is that

Hi, getting ready to install Black Bear ECM into my '97 2Dr Tahoe. Anything to do other than plug it in? They sent no instructions. I read something about having to do a crank relearn. Thanks.

A few days ago I bought a beautiful used 2017 Canyon All-Terrain but lo and behold it had this issue. I'm SO glad I found this video early on after buying and I bought the screen and glue to fix it. Thanks so much for this!!

Back end looks lower then the front😥

Great video. My ‘15 Silverado had the same problem a year ago which resolved after removing and re-inserting the fuse on passenger side fuse box. It returned after I had electrical problems which turned out to be bad battery ( despite Advance Auto using their $3,000 diagnostic machine, telling me the battery, starter and alternator were “ fine “ ). The second time I could not change channels properly with finger or paddle, it would always go to one of the preset channels. I replaced the digitizer and now blank screen, although I do get audio, still goes to one preset channel when I use paddle. I’ve removed radio fuse, blue connection in back of glove box and disconnected negative battery cable, all simultaneously and still no screen. Should I replace motherboard ?

I recently started having this problem on my 2019 silverado LD, was looking at a pioneer replacement. Took the the assembly out, saw that all around the edges was sandy dust that had worked its way behind the bezel. I'd seen a couple of these videos and wasn't sure if I wanted to go this route. After checking out how it's all put together I cleaned the whole touchscreen from edge to edge before installing it back into the bezel. I haven't had the problem since, so far. I'm not saying these screens don't fail, I retired after 40 years a tech. But before you spend the money, I've seen them priced anywhere from $30 to over $100, give this a try. Taking it apart and putting it back togetther is fairly easy. Good luck with yours!

Yours is coming along nice and your doing a great job. I did the RedHead Quick ratio steering gear box my only complaint is at times when you go to turn from a dead stop it doesn’t turn. You can feel the pump pumping through the intermediate shaft(Cunningham Machine upper/lower) but the box just doesn’t do anything. I’m 18k into mines w/o replacing my motor/trans or rebuilding my diffs yet.

Looks good.. I am at a cross road . thinking about rebuilding my 5.7 Vortec or swapping it out to an LS motor. can you give me a lil advice. should I rebuild or swap?

I just put mines on home screen and it works fine

How many yards or in of fabric did you order? you helped me with the thickness awhile back, it'll be a big help

Thank you so much for your content, instructions and links to the part. I ordered the replacement digitizer from eBay per your instructions (for a whopping $31 😄), and looked up other youtubers for the disassembly and replacement, and it now works flawlessly!

Did you try it with the rear shackles before you put the double caradan drive shaft?

Did you try it with the rear shackles before you put the double caradan drive shaft?

I drive a 300k+ miles 2017 Chevy suburban for work and the audio system did the very same thing. Now it only turns on for a minute or two on start ups then goes off completely. 🤷🏾‍♂️

Nice video

Very nice video 👍👍👍

Prize Kingdoms game review is interesting. Your explanations are top notch. Thank you for sharing the video to the viewers .

Very interesting video... thanks...

Amazing video.. Really impressed this video. This game is so amazing.. Thank you for sharing this video..

This game is amazing. Thank you so much for sharing this amazing review. I definitely try this. It's really help me

Great video everything is explanation very clear thank you for sharing

Amazing and very informative video. Very detailed and well explained video. Your content is very nice. Every body understand is very quickly. Thank you for sharing in this video.

This is an amazing video regarding prize kingdom and the way you give the review regarding this game is superb. Thanks for sharing the details information.

Very nice and detailed review and thank you for sharing us this .

Prize Kingdoms Game is an amazing video.Thank you for sharing this video with us.keep it up.

This is amazing! I’m really impressed by how much you've earned with Prize Kingdoms. Your success is truly inspiring, and your review has made me eager to give it a try. Thanks for sharing your experience and being so open about the process. I'm excited to sign up and see where it leads!

Very useful information

Nice video thanks for sharing

Very nice video. Everything is clearly explained. Thank you for sharing this with us.

Interested game thank you for sharing