วีดีโอ

Thank you so much . I ordered a plug, should've looked on here first.

I know it's an old video but I have a 150 Opti and it ran good twice after taking it out for the first couple of times. I took it out the 3rd time and it started fine, idled well but as soon as I put the throttle down it stalled. It would start and idle well every time after that but die straight away at about 2500 rpm. I had to chug back to the marina at 3 mph, anything more and it would stall. I am changing the fuel hoses. I have a water separator in the boat as well. I will also change the filter on the outboard. Any idea what you think my issue might be?

Haven't ever caught a tog before. Looks like he was almost something/someone elses dinner! New sub from my channel to yours

What year is this?

Thanks for the great breakdown, is there not an additional in-line fuel filter as well?

80HP MERC WHILE IN STORAGE THE WHOLE OIL TANK LEAKED EMPTY. 2 STROKE.

Do you have any pics close up with the motor in its stored position??

Do you need to take out all the oil from your bigger oil resevoir that’s on your boat first? The hoses you take off the small oil tank when you replace it from the motor won’t leak out since the bigger oil resevoir that’s on the boat is filled up ?

Bought two filters and neither one would screw on past two turns. What gives?

What year is that one

I just bought a mako 191 with a optimax 135 and it starts and idles fine but under a load it falls flat on its face and I get an alarm (it looks like a piston on a crank shaft) for a misfire. Any suggestions?

I think I might see ya out there 2024

Part #?

2390710 battery part number.

Wouldn’t a cast net be more effective?

What’s the part number

When you swapped the filter did you have your do anything else? Will the oil start to flow back up to the canteen oil reservoir?

What’s the part number?

I have this same motor can someone direct me where the carburetors are at? Are they imbehind the intake?

I want to install this on my 285 Conquest. Would you please show a close up of the mounting? Also, would you please show how you deploy and stow it with the bow rail? Thank you!

New video was very helpful thank you so much

Not at thing you'd want to do while bouncing around on the ocean, and unable to get the motor to stow, because of a bad battery in the remote. 🤨

How did u do this year

Thanks a lot, I just replaced mine, following your video. Worked perfectly. Your video gave me the confidence to buy a replacement battery and change it. 😅

Unlike MinnKota they gave the battery part number. Hello McFly!!!!!!

Salty Grunt? We’re you a Marine on an amphibious assault ship? 💪🏼⚓️🇺🇸

👍

Whats the part number?

The part number would be nice to know

Hello, what is the type of this battery ? I'm French, bonjour de 😂France

horrible filming

Nice !

Any word on 2023 ?

you slobs put the fish right on top of your water bottles?

nice

How well does it hold? We have a 28 luhrs open and just curious if it will hold that. We also have a 22 scout CC with a trolling motor that works flawlessly so I know they work. What LB thrust is this motor?

whats the part 3 for battery

Rod/reel combo?

Nice Tog man!

Hi There. where did u get the aftermarket oil tank assembly from? I have not found one for my 90 ELPTO 2 stroke. Thanks

I struggle with that filter every year

That bat was crazy!

Great time, Ryan! Excited to do it again soon.

HI, Very good video(even in he High wind). Im having 'Chugging' above 4400 rpm on my 2001 Optimax 200 DFI. HAve you opened up the VST? have you made a video of it? (same as Tania Scarlett comment below.) I have done new Plugs/Fuel Filter/Impeller/Checked all coils and/ wires. Now I need to look at fuel... Injectors/VST/ Sender and cannot find a diagnostic video on how to do a 'checklist'. THis engine is new to me this year (previously an Evinrude guy for 30 yrs). It seems you have the same GEn of VST on your 225. (1999-2002?)

Keep

Good luck sometimes i go for fishing i get a shoes or empty cans.

Oh ya boys! Looks great out there!!!

Nice

No idling for me……keep it movin’

Nice video, please show us how to change the high and low fuel pump next time please