วีดีโอ

I loved the KO2, but I experienced the similar wet weather performance you mention. I experienced rear wheel slip when accelerating from stops in wet conditions. And standing water was an issue. However, I purchased the KO3 as replacements. Though I still have not tested them fully, I have note experienced the wheel slip at the light in wet weather.

Sooooo….. judging from the comments, some people have good luck with SPC, some bad. But all JBA comments are nothing but good. Says something

Thanks for the review. I was about to hit buy on these, but your wet performance review gives me pause, as that's probably the biggest "weather" that I deal with on a regular basis here in the Seattle area.

I don’t get my wireless CarPlay to work… any advice?

Do you know if the 2006 4Runner limited has 29 or 30mm sway bar bushings?

You should do a brake fluid video!

Thanks for your information. Cheers.

Hey was the 1 gallon enough for the rear?

How I fit 33” on my 4Runner : 1. Kept factory offset wheels on ORP (saved money & saved turning arc that eats into clearance) 2. Bought 33” tires and had them mounted and installed on the vehicle

Whats the price?

Can i get a link to place order on the same setup?

Lame

Hey, does the usb port under the armrest also works for this or just the port in the dashboard? My usb port in the dashboard is broken thats why raising the question 😢

Add the yellow fog light would go nice with it.

The reason I went with the KO2 on my Tacoma was the weight. Looking at similar tires, the KO2 turned out to weigh the least and the Tacoma isn't a powerhouse to begin with. I have been careful about driving in the wet based on all of the reviews, but I have never hydroplaned on these. We don't get a lot of rain anyway, so it isn't a big deal, but this definitely is not a good performer on wet snow. I've slid around on these and that was not confidence inspiring. Would I buy them again? Probably yes, if we are talking about an underpowered vehicle. If other tires become lighter then I might switch in a few years.

Post installation, with the SuperPro lower control arms, do you notice more vibration, otherwise feel the road more?

What headlights are those? Really sick rig man. Looks clean as hell but not overdone.

Damn what tires are those and how high of a lift is needed?

How many of those 1L bottles did you use?

What are the specs?

Great video, we have these tires on my wife's 2016 wrangler no issues living in buffalo NY area seem to good in wet roads also great in snow , no problem with wearing...But in my opinion as you stated you can get a better tire for less I have been running Atturo trailblade XT on all my trucks for the last 8 years they handle better than the BFG in all conditions....

Is there a video anywhere of installing the plates people speak of?

What’s the part number for the LED?

I don’t want to buy this specific fan, seems overpriced and you don’t know the CFM. Would you mind measuring the diameter so I can find a replacement?

What does this badge signify?

Hey man, are these the HD brackets or the regular Sherpa brackets?

this might be a dumb question, but what is the difference between these UCA’s and say the straight kind like the stock ones?

auxito makes good stuff

If the pump is already bad and it’s making the noise and my check engine light came on today does that mean I have to pull the pump out and clean out the system or can I just put a bypass kit in and clear the codes and call it a day ? ?? 😮😮

Had JBA’s for two years, no issues.

The SPC xAxis bushings strike again

Looks good! One thing I’d add for any others considering the SPC UCA’s, these actually saved my bacon following my lift because my alignment cams in the LCA’s were seized. Having the adjustable UCA’s allowed me to get my alignment well enough within spec that I could drive around without chewing tires until I had the time to cut off / replace the LCA’s and cams.

Going to look at a 4.7V8 06 with 180k miles, it’s going for 7k I think it’d make a fun winter project, this is what I hope I can turn it into 😂

Greetings, where can I get that roof rack?

Yea can't afford v8 gas, so i settle for my v6 05 4runner 😅

This is an awesome stance! Do you have the specific spring #?

Will this happen eventually to every VVTi V8? I have 176k on my 06' 4Runner with no issues. Does the SAIS fail at a certain mileage?

Thanks for the video. What do you do for a spare tire? Will these fit in the designated space for the spare?

What did the wheels and suspension lift kit cost if you don't mind sharing?

I literally just trimmed the bumpers on my 05 this weekend, looks great. Watched as many videos I could for ideas but ended up keeping the center and mudflap bracket trimming 2in off the bottom and used an axel nut for the curves and put black trim on. Looks like it should have been a factory option lol

What are bump stops for?

How long was that bolt?

They are deadly in heavy rain!! I'll never buy them again

Hey! Watched your video and noticed it was from 7 months ago. Was wondering if you were still gonna do an update video on this head unit. A bit curious if your impressions have changed after 7 months of using it. Thanks!

Totally agree on the wet performance…..Ran them on a Yukon for 10 years in a very wet place, standing water at speed is scary, exactly as he said…….Switched to Yokohama GO15’s which plow through deep water no problem!

Just got the AT4Ws and they're incredible. No road noise, no negative impact on gas, looks great, and even fully aired up has insanely good traction offroad

I seen the video about fitting the 35s but was that everything you did? I’m up in the air about what all I need to do to get them to work. I see so many different things about what you have to do. I have a 3” lift right now and I have jba uca’s

Nice video, I’ve had my SPC going on about 50k miles I wheel pretty hard, daily drive and even now doing little jumps with the truck. I’m on bilstien 6112/5160 and sumo spring bumps. I regularly grease them every oil change as recommended. Not a single issue with them. I was considering JBA but I had ran SPC coilovers and camber control on my old Honda so I knew they were a trusted brand with years behind them so I went with them. Sorry to hear others had problems

What all did you do to get the 35s on

Your ball joint is bad. It isn't the adjustment that caused this.