- 19
- 10 375
unseasoned project cars
เข้าร่วมเมื่อ 23 ก.ค. 2021
How to videos on timing belts, engine rebuilds, engine installs, and more.
Like and subscribe.
Like and subscribe.
06 Impreza 2.5i part 4 head install
installing the heads on a 06 impreza 2.5i.
I used the DNJ gasket kit with multi-layer steel head gaskets
I used the DNJ gasket kit with multi-layer steel head gaskets
มุมมอง: 15
วีดีโอ
06 Impreza part 3 engine, timing assembly and head removal
มุมมอง 172 ปีที่แล้ว
removing the impreza engine disassembling the timing belt assembly and removing heads From a 2.5i sohc
impreza wagon part 1
มุมมอง 72 ปีที่แล้ว
a quick run through of a 2.5i engine pull out of a 2.5i impreza wagon
EGT sensor resistor mod
มุมมอง 6K2 ปีที่แล้ว
the up pipe I ordered did not a spot for the EGT sensor so it was either buy a new up pipe or do the resistor mod!! #subaru #impreza #outback #ej25 #project #
top mount intercooler removal/install 06 outback xt
มุมมอง 4252 ปีที่แล้ว
removing and reinstalling the top mount intercooler on this 06 outback xt
ej255 short block introduction
มุมมอง 582 ปีที่แล้ว
working on a ej255 short block for the impreza. this is just the start #ej25 #subaru #project #sohc
first start up
มุมมอง 472 ปีที่แล้ว
first start up after timing belt replacement and head gasket replacement
timing belt install
มุมมอง 662 ปีที่แล้ว
ej253 timing belt install directions both cam gears timing marks are set at 12 o-clock. crank gear timing mark lines up with the mark on the crank sensor housing
update on the cause of the head gasket failure
มุมมอง 512 ปีที่แล้ว
update on the cause of the head gasket failure
finally got around to pulling the engine
มุมมอง 582 ปีที่แล้ว
finally got around to pulling the engine
I did this on my automatic ‘05 legacy GT a few weeks ago after installing a catless up pipe, it worked up until today and now my sports mode, cruise control and check engine lights are all flashing. Do you know what the fix to this could be? I used the 2.2k .5w ohm resistor, do I need to clear the codes? Take it to a shop to get tuned for the mod? Appreciate any help!
How did you determine what resistors you needed?
Try forums
Its been a while since I worked on Subaru I googled resister mod for my xt at the time
Where can I find one of these mods I search it up on google and it shows me to those car group chats
You can order the resistor off Amazon or eBay. type of resistor should be in the video
@@unseasonedprojectcars6898 I did the resistor trick and it worked for almost a year but today it stopped working for the o2 sensor, and today i got these new Spacers for the sensors they work great no lights on the dash working perfect.👍
What are the little things at the ends of the resistor wire? Did you coil them?
how many resistors would I need as my 02 sensor has 4 wires.
I haven't done it for o2 sensor at least not yet
Best to replace o2 if it has a problem
The other light that is on , Is the Fuel low light and Do not let your fuel gauge go that low as to it can Blow your Fuel Electric Pump in the Tank big dollars to replace,
Lol it had been sitting for half a year and just got it running again. But i try not to let it get under half a tank
@@unseasonedprojectcars6898 I'm curious seeing how it's been a year since this post, how long has the sensor bypass worked? I'm replacing the up pipe on a bugeye wagon with the same issue, new up pipe has no spot for the egt sensor and considering this route.
Still works til this day and sold the car no cel till this day. If r resistor goes bad CeL will come back just replaced the resistor
I have since we went to the dark side and purchased a sn95 mustang for project
Need more step by step videos and more detailed videos but keep at it.
I'm working on it
There is way more to come!!! Please stay tuned!!!