ฝัง
- เผยแพร่เมื่อ 15 ก.ย. 2024
- P80 lower build. This is my first build. I saw that many said you don't need a drill press. I want to get one but in all my tools don't have one. So I used my dremel with a sanding drum and small cutting ball. I also used 100 and 800 grip sandpaper and a laminate file. It took me longer than 30 mins but I went slow. Over all not difficult. The slide off of my 19 works but is a bit sticky. I may need to do some work on the rails. This is where it seems to be doing some binding. I believe it will shoot fine but if the slide is let go slowly it will not snap into battery. A slight tap will push it in but this shows its a bit too much friction. This is withe no oil.
U should just cutt the tabs they come out clean that way just get u some flat nose snips..from John from maine penobscot county
Even if you cut the tabs you need to file it smooth. There are several ways to do this job and they all seem to work fine. So what ever works for the person doing the job.
You still have to file the remains or sand it. There are several ways to do it.
Just use fret cutters for tabs ND a some sandpaper PS polish ur rails using 3000 grit ND gun oil and make sure your u channel is smooth by fingering it using ur pinky ese
@@TheSmokey817 There is not "right way to do this job." there is not really anything you are doing that will need any particular fine sanding as the rails are metal and inserted once you finish making the frame. If you are referring to the actual steel rails, you don't need to polish them. It will work just fine without. If it makes you feel better you can get a Dremel and the polishing wool bits and some red rouge compound and polish the feed ramp and rails if you like. I don't think it will do all that much but it will not hurt unless its way over done. The U channel is the same. No need to polish, It should not touch anything of the barrel, spring or slide so as long as the clearance is good I would not worry about polishing it.
where can I get the full kit so I can be able to do this as well
I don't know if you can buy it all one shot. Biden shut down the kit. But I did read the courts shut that down. You may have to buy them separately. But poly 80 is a good one and you can get them on sites like this www.80percentarms.com/glock-80-lower/
how long did the process take? i’m looking to do this over the weekend
30 minutes
I'm going to look for part two just to shake my head more..
Shake your head at what precisely?
Not that I care but, it’s because you dremeled the tabs which can heat up the material and melt onto the frame. Makes it more sensitive when your doing precise work. Again not that I care but razoring the tabs off and a little sanding would of saved you some time. At least you tried to help others instead of just rag on people.
does it matter what file you use?
what ever works for you. You can sand it after to smooth it out or use a dremel.
0:33 how do yk how far to go down
Level with the jig.
The jig
how do i get the case
Do you mean the JIG? Unless you bought the frame alone from a third party it comes with the JIG. I sold this gun as I did not need it. I wanted to see how hard it was to make it. Turns out not hard at all.