How To Use Mooer GE150 as an Audio Interface

Time Lapse
00:10 First Part (error when selecting inputs and outputs)
05:00 Second Part
How are you!
Today I bring you a new video of how to use our mooer ge150 in audio interface mode, for this I used the FL 20 DAW, since it is the one I currently use.
Then I will leave the steps to follow that begin 5 minutes into the video ...
First of all, you must connect a micro USB cable to the connection that says OTG and connect the other end on the PC to a USB 2.0 or 3.0 (if you have problems with 3.0, try it with 2.0) at this point the Computer will take a few few seconds or even minutes to recognize the Mooer (it all depends on your pc). It should be noted that the Mooer GE150 I have updated to the latest version 1.3 (point that can be decisive, here is the link on how to update: • Como actualizar Mooer ... and • Nueva Actualizacion 1.... )
We plug the headphones into our computer. We select the reproduction device in the lower right corner: Speakers (most likely it also says realtek).
We start the DAW FL we go to Options, select "Audio Settings", then we click on Buffer Lenght we verify that in Input (input) it says: "several microphones mooer GE150" and in output: "Realtek Speakers" and we be ready!
The final result will clearly depend on your Computer, since the sound card of our PC will be in charge of the reproduction and not the Mooer, so there will be a small latency, which will be higher or lower depending on your PC. This method is applicable for other DAWs following the similar steps, the important thing is to select the inputs and outputs correctly and that the DAW as such has its own controller to manage the inputs and outputs as FL ASIO does.
Greetings, and I hope this helps.
Thanks For Watching!!!
Listen To Me On:
open.spotify.c...
1663bc.bandcam...
Follow Me On:
/ seba_1663
#mooerge150
#interface
#usb
#1663
(\____/)
( ͡ ͡° ͜ ʖ ͡ ͡°)
\╭👉 \╭👉