Mach3 Spindle with VFD inverter Wiring and Config

Mach3 can control the spindle via a relay or VFD inverter.
There are lots of VFD brands, and all the wiring to Mach3 is the same. Maybe terminal labels have different names, but with Manual, you can find the needed terminals.
Here I have a Mach3 red board, a 750 Watt spindle, and a 2.2KW VFD, and I am going to show you how to make them ready, wire them, and also config them.
This is a quick guide and demonstration with all the steps that I have done.
Nothing special, but it gives you a big vision.
Hpmont HD09 manual: drive.google.c...
mach3 wiring diagram: drive.google.c...
Music: Desert Music ( • Desert Music - Ethnic ... )

[@هومناکبری-م8ر]

چه دستگاهی به به

[@tonyn9632]

Hello.
I'm trying to connect the attached drive and spindle to the same Mach 3 board you have. but is not working. Maybe I programmed wrong. Can you advise?
LCRHLCNC 110v Spindle Motor Kit，1.5Kw Square Air Cooled Spindle Motor 24000Rpm 400Hz，VFD Variable Frequency Drive，

[@manifa59]

Hello
Does it have any manual that I can look at?

[@AmirMahmoodKheirabadi]

سلام. من یک برد مثل شما و یک اینورتر متفاوت دارم. حدود یک ماه است که تلاش می کنم نحوه سیم بندی صحیح را پیدا کنم. اما موفق نمی شوم. البته در mach3 موتور روشن می شود. اما فرکانس تغییر سرعت ارسال نمی شود. براتون امکان داره من عکس سیم بندی روی اینورتر رو بفرستم و شما راهنمایی کنید که باید سیم های ACU و ACL رو به کدوم مورد وصل کنم ؟

[@manifa59]

سلام
من در خدمتم ، بفرستید با هم چک میکنیم
تلگرام هم میتونید پیام بدید
@mani_fa

[@AmirMahmoodKheirabadi]

@@manifa59 خیلی لطف می کنید. من ایمیل کردم براتون

[@manifa59]

اوکی

[@kenf2662]

Hello, Very important what was your Spindle Motor Tuning numbers Steps Per, Velocity, Acceleration, Step Pulse, Dir Pulse

[@manifa59]

Thanks for reminding

[@TouChA0]

you don't face any problem using mach USB board

[@manifa59]

You mean noise and some sudden disconnection?
If you use a short USB cable and connect the earth cable correctly , most of the problem is solved automatically.
I have not had any problems yet.

[@TouChA0]

@@manifa59 connect usb cable to ground how

[@manifa59]

I do not mean to ground the USB cable , you need to ground your CNC , Drivers and inverter to reduce noise .

[@TouChA0]

@@manifa59 but i didn't see grounding in the drivers maybe vfd ground is PE

[@bdeconcept383]

You need to used shielded cables and Noise filter

[@goutampatra6200]

Ami warking shik bo sir

[@manifa59]

Hi
Great