Universal Top Mount Marine Boat Single Lever Throttle Handle Engine Control BoxControl Box Black

Cable connected to red pin is the acceleration comes from engine.
Cable on the left side is the gear cable.
It is recommended to place and connect the cable close to the left side of the box.

[@luiseduardogalante5274]

Hola para aselerar hay que abrir la palanca

[@luiseduardogalante5274]

Cómo se llama la goma que lleva entre la palanca y el cuarto

[@jonathanpal3123]

thank you so much for posting this video. it helped me out so much!

[@deepworldlive]

Thanx, perfect post!!

[@jejoko]

I'm hoping you can help me out.
I have twin yamaha's and my forward controls are not opening the throttles at the same rate. They start out fine at first but then the more you give it gas the larger the discrepancy between throttles. When I run at high speed the right handle has to be more forward that the left for both engines to have the same rpm.
I thought at first that the throttle/cable parts/levers on the outboards could be loose or worn out. But they are fine. Both have been synchronized at neutral and at idle. Both idle at 700 rpm.

[@robert3325]

Hi, where does the "carby throttle cable" connect to?

[@Ivarykk66]

where can I get one of these universal controls

[@AlejandroRodriguez-vn3cu]

Can you send me the accessories that you used for the lever like the screws and plastic

[@willhendry1879]

best presentation

[@scottcoleman284]

I bought one of these, it came without instructions. This video is helpful but can you show how to change it from pull cable throttle to push cable throttle?

[@MrTopshelf333]

Pull the sticker off the throttle on the outside of the handle (at the pivot point) to reveal a screw. Remove screw, wiggle handle off, then Push the throttle gear in ( from inside the case), like You are trying to run the throttle only, and spin it a half a turn, so the pin for the throttle cable is at the 12:00 position instead of the 6:00 position.

[@stefangreencorn]

Foresale?