Is there any way to ignore inertial affects during a dynamic analysis? What really want is a static force balance but run through 360 degrees of the crank,
Thank you Sir for uploading such a nice video. Sir I want to apply a constant speed and want to measure the 1) acceleration Vs rotation angle, 2) velocity Vs rotation angle 3)Torque Vs rotation angle... How to do it?
Your microphone pops are out of control dude. Watch your "P" sound pronunciation. Use compression, buy a better mic, a pre-amp, a pop filter, and control your vocal dynamics because I can't even focus on what you're saying.
@11:25 you were calculating centripetal acceleration that's why it wasn't zero :) Thanks a lot for the awesome tutorial
Awesome!
Is there any way to ignore inertial affects during a dynamic analysis? What really want is a static force balance but run through 360 degrees of the crank,
can we give sub assembly mechanism into the main assembly
Can you make a video on how to do stress analysis on assembly in creo
have to assigned mass properties to every individual part or just one part ?
Thank you Sir for uploading such a nice video. Sir I want to apply a constant speed and want to measure the 1) acceleration Vs rotation angle, 2) velocity Vs rotation angle 3)Torque Vs rotation angle... How to do it?
Can we do engine balancing in creo ?
Thanks a lot for this great tutorial ! could you make some tutorial on bevel/spur or helical gear that would be so great ! thanks again for this video
+saadamiens Working on it, Will probably have time to finish on thanks giving break.
Great
saadamiens
Excuse me, can I draw a screwdriver, I think I still can't figure out how to draw, thank you very much
Our CAD Lab Engineer sent us a link to this tutorial instead of making a lecture himself in Distant learning, lol
Assignment bna li
Haan
@@alisaim8260 wow
ali saim bhai naraz kuin ho raha hy
@@muhammadjunaidkhizar3987 Galt banda tag krdia shah jee apne
You need to get to the point faster. I could have shown how to use this in 5x less time.
Your microphone pops are out of control dude. Watch your "P" sound pronunciation. Use compression, buy a better mic, a pre-amp, a pop filter, and control your vocal dynamics because I can't even focus on what you're saying.