Below is a link to the SlideSmart installation video. At about the 9:15 mark they describe setting the open and close limits. Also below is a link to the Quick Start guide for the operator, on page 6 it describes setting the limits. Hope this helps. th-cam.com/video/TYN8PXjAIk4/w-d-xo.html support.hysecurity.com/hc/en-us/articles/360043165574-SlideSmart-DC-Quick-Start-Guide
I’m getting a stop command on my smart touch controller board and it’s overriding all other input commands. There’s a red light next to the stop terminal. I removed the wire and connected a jumper from the stop terminal to common and that bypassed it, allowing the gate to slide open and closed. I’m trying to figure out what could be commanding it to stop if none of the stop buttons are pressed. I’m assuming those stop buttons are normally closed.
Rick Tatorship, what is the wire that you disconnected going to? That device is probably the culprit. Commonly the photo eye or edge sensor will be attached to the stop terminal.
Hello, currently I am replacing the STD. However I accidentally set the OT menu to 0. Is it possible to change it again? I try to find OT option but can't be found to change it. Any help will be apreciated . Thank you 🙏
I have a problem with the screen and the keyboard. I have an old engine and I updated the keyboard (like the one you have) and the problems do not appear on the screen, it just says “HYSECURITY”. Can you help me, does something have to be modified in the software?
You need to do a video on how to re learn the open and close stops
Below is a link to the SlideSmart installation video. At about the 9:15 mark they describe setting the open and close limits. Also below is a link to the Quick Start guide for the operator, on page 6 it describes setting the limits. Hope this helps.
th-cam.com/video/TYN8PXjAIk4/w-d-xo.html
support.hysecurity.com/hc/en-us/articles/360043165574-SlideSmart-DC-Quick-Start-Guide
I’m getting a stop command on my smart touch controller board and it’s overriding all other input commands. There’s a red light next to the stop terminal. I removed the wire and connected a jumper from the stop terminal to common and that bypassed it, allowing the gate to slide open and closed. I’m trying to figure out what could be commanding it to stop if none of the stop buttons are pressed. I’m assuming those stop buttons are normally closed.
Rick Tatorship, what is the wire that you disconnected going to? That device is probably the culprit. Commonly the photo eye or edge sensor will be attached to the stop terminal.
Hello, currently I am replacing the STD. However I accidentally set the OT menu to 0. Is it possible to change it again? I try to find OT option but can't be found to change it. Any help will be apreciated . Thank you 🙏
I have a problem with the screen and the keyboard. I have an old engine and I updated the keyboard (like the one you have) and the problems do not appear on the screen, it just says “HYSECURITY”. Can you help me, does something have to be modified in the software?