Hi guys, great work with the vids, keep them coming. That yellow thing at the bottom is a tap to drain/bleed water from the fuel filter. The cable is a sensor that can send the car into “restricted performance” if it detects moisture in the fuel. Or if the sensor fails it will go into “restricted performance”.
Legends. I went n made the bad decision of priming the filter on my 08 TDV8 the drain plug cracked so I knew I had new Fuel coming through Now it won't start N I've trapped air in the line. Any vids or tips on how to sort that? Wish I knew it had a ''Self bleed'' System before I primed it through the Drain plug dammit! Haha. Less room with the V8 exhaust system too.
Hi I have a problem with our 2010 3.o diesel, sometimes will just turn over without starting and others times it fires first turn. I put a scan on it and came up with the codes P060B, P064D and P062A can someone tell me is this a fuel fault in the tank or high pressure or something else, any help would be great, I'm in outback Australia miles from help. thanks Peter.
I have a 2013 Discovery 4 SDV6 and should get around 871 km to the tank. This will most likely be less but I'm consistently getting 600km to the tank. Are there any tricks of the trade to reduce fuel consumption on these? Great work on all the videos by the way 👍🏾
Hi is there any chance you can show us how to change the fuel filter housing ? As there is a common fault with this with warning light coming on water in fuel,and a new housing rectifies this problem cheers
Yeah. Had this fault on my 2013 D4 and changed the sensor which didn't work till we changed the whole housing. You have to remove the cross member under the housing. Just be careful when you do as it holds up the fuel tank meaning the tank will drop when this is removed.
We managed to change the housing without removing the cross member. Was a bit fiddly. Managed to loosen the the housing (2 bolts at base) and tilt it to one side to undo the 3 small 7mm bolts on the top and changed the component 👍🏻
Hi guys, great work with the vids, keep them coming.
That yellow thing at the bottom is a tap to drain/bleed water from the fuel filter. The cable is a sensor that can send the car into “restricted performance” if it detects moisture in the fuel.
Or if the sensor fails it will go into “restricted performance”.
Great effort getting the camera there for all to see clearly !
you guys are hero! Thanks for taking time to show how to do it.
Great video. Used this for last couple of years service
Glad it was helpful!
Thank you once again, you guys are my go to, I couldn’t find the bloody filter anywhere 👍
Great, I did my Discovery 3 LHD today after watching this, perfect..like the chat too.
Thanks guys
This video came in very handy today 👍🏻
I am not a master technician but glad it helped
Loving the videos. Thank you.
Any idea what the little electrical plug at the bottom is ? Mines missing.
Hi guys thanks this diesel filter change help me a lot
Great to hear!
Cheers great video I think it took longer to remove bash plate bolts than replace the filter after watching this video
Legends. I went n made the bad decision of priming the filter on my 08 TDV8 the drain plug cracked so I knew I had new Fuel coming through Now it won't start N I've trapped air in the line. Any vids or tips on how to sort that? Wish I knew it had a ''Self bleed'' System before I primed it through the Drain plug dammit! Haha. Less room with the V8 exhaust system too.
Are you aware that there is a fuel pump low pressure bleed point at the rear of the engine?
Hi I have a problem with our 2010 3.o diesel, sometimes will just turn over without starting and others times it fires first turn. I put a scan on it and came up with the codes P060B, P064D and P062A can someone tell me is this a fuel fault in the tank or high pressure or something else, any help would be great, I'm in outback Australia miles from help. thanks Peter.
I have a 2013 Discovery 4 SDV6 and should get around 871 km to the tank. This will most likely be less but I'm consistently getting 600km to the tank. Are there any tricks of the trade to reduce fuel consumption on these?
Great work on all the videos by the way 👍🏾
EGR delete…… 😢
what a place to put a fuel filter??
Hi is there any chance you can show us how to change the fuel filter housing ? As there is a common fault with this with warning light coming on water in fuel,and a new housing rectifies this problem cheers
Yeah. Had this fault on my 2013 D4 and changed the sensor which didn't work till we changed the whole housing. You have to remove the cross member under the housing. Just be careful when you do as it holds up the fuel tank meaning the tank will drop when this is removed.
We managed to change the housing without removing the cross member. Was a bit fiddly. Managed to loosen the the housing (2 bolts at base) and tilt it to one side to undo the 3 small 7mm bolts on the top and changed the component 👍🏻
Anyone know how to do this on a 2018 TD6 Discovery 5?
Спасибо!