Unboxing the LTP5500D Digital Plasma cutter for upcoming Plasma Table build with JD's Garage plans, for your own plasma table plans go to www.youtube.co...
Just got mine yesterday. My model is LTP5500DCNC. Hopefully, the CNC designation indicates the updating of the original D to a more CNC specific configuration.
Machine works great, I don’t use it a great deal but do have lots of plans for it. I have an old shop compressor that makes lots of air so I never worried about it, I can’t even think what the CFM is off hand?? It way more than what’s required to run this machine. The JD’s machine doesn’t require huge air, I couldn’t honestly answer what the minimum CFM would be?
I ordered mine from Amazon.com “Lotos Supreme LTP5500DCNC Non-Touch Pilot Arc CNC Enabled Digital Plasma Cutter THC Torch Height Control Enabled, Dual Voltage 110V/220V,3/5 inch Clean Cut, Brown (55amp CNC)”
I saw you cut 1/4 in on your cnc table, how where setting, amps, air pressure, speed? I have the same cutter on the same table, but it's not easy to cut 1/4 in with the settings indicated in the book. Thanks
I just had it...and when the contact switch is turned on the cooling fan doesn't work right away...does the system work after the engine is hot it just starts working
Just got mine yesterday. My model is LTP5500DCNC. Hopefully, the CNC designation indicates the updating of the original D to a more CNC specific configuration.
Sounds like it, I bought mine about 20 months ago so they may have upgraded since then
Great videos, thanks for showing the build processes
Thanks
Thank you for sharing. How is the machine holding up? And can you share what your air compressor cfm rating is?
Machine works great, I don’t use it a great deal but do have lots of plans for it. I have an old shop compressor that makes lots of air so I never worried about it, I can’t even think what the CFM is off hand?? It way more than what’s required to run this machine. The JD’s machine doesn’t require huge air, I couldn’t honestly answer what the minimum CFM would be?
Did you order the ltp5500d or ltp5500dcnc? I know the box showed the ltp5500d but the back looks like it’s the ltp5500dcnc version.
I ordered mine from Amazon.com “Lotos Supreme LTP5500DCNC Non-Touch Pilot Arc CNC Enabled Digital Plasma Cutter THC Torch Height Control Enabled, Dual Voltage 110V/220V,3/5 inch Clean Cut, Brown (55amp CNC)”
I saw you cut 1/4 in on your cnc table, how where setting, amps, air pressure, speed?
I have the same cutter on the same table, but it's not easy to cut 1/4 in with the settings indicated in the book.
Thanks
May I ask where did you connect your plasma cutter to control the relay switch, I'm having problem with mine.
I just had it...and when the contact switch is turned on the cooling fan doesn't work right away...does the system work after the engine is hot it just starts working