Hi Paul, Was that the one I had in the workshop ? I gave that one away. I did do a review using it and then managed to delete the finished one. I had also dumped the clips, so it is gone forever. Will do one on the RTECH welder I use on the boat . I also have recently got a RTECH 3in1 I have in the workshop , both excellent machines. Andy
Hi Andy, just a quick question, the welding torch doesn't have a shield on it, do you use a flux cored wire and suitable feed? Used Tig (inside) and Mig with gas (outside and with shielding so the gas is usually still around the tip of the torch) Cheers Ian
I just filled them internally as they were plated over externally already. I didn't make it very clear unfortunately. The working ones are to the right ,the old one on the left. Don't know why that was done originally.
Fishing is just an excuse for sitting by the water's edge, pondering the meaning of life. Catching actual fish is a distraction. (This is my reasoning, and I'm sticking to it!)
I love this blog the craftsmanship is just brilliant thanks Andy😊
Cheers James .Pleased you enjoy watching. Andy
Love watching your work, I'm being educated by the way you go about tackling different jobs. Very skilled man indeed. 👏
I appreciate that David! Andy
Bloody good job there Andy :)
Cheers Flash ,looking a lot better know. Andy
Can see on the inside also that the door is not central. Fab work, love watching it
Cheers Emma. I don't know why it is off center , but does noteffect anything though. Andy
@@nogunwales9406 possibly the kitchen was at the front and 1 side was wider for full size work tops and the other side was a 3/4 worktop
@@DEmma1972 I think you are right Emma it was like that.
You’ve got a lot done now Andy, sad day when the fish don’t bite 👍👍👍👍👍👍👍
as we say round here water licked
I just know I would be banging my shin/ankle on the sharp points of your great steps! But then I'm not too graceful! LOL
Hi Andy, how about a review of the welder you bought at the beginning.
Hi Paul, Was that the one I had in the workshop ? I gave that one away. I did do a review using it and then managed to delete the finished one. I had also dumped the clips, so it is gone forever. Will do one on the RTECH welder I use on the boat . I also have recently got a RTECH 3in1 I have in the workshop , both excellent machines.
Andy
👍👌❤️🇨🇦, gr8 stuff
Cheers Pockets ,Thanks for following. Andy
Always great to watch your videos. Are going to install a cover over the well deck to keep the rain out now you have blocked the drain holes?
Hi Andy. I'm keeping up with yer. The great god Pisseden is always there to stop progress. Typical eh
It sure is Garry, I suppose Summer will arrive sometime. Andy
Hi Andy, just a quick question, the welding torch doesn't have a shield on it, do you use a flux cored wire and suitable feed? Used Tig (inside) and Mig with gas (outside and with shielding so the gas is usually still around the tip of the torch) Cheers Ian
Good job Andy. What were those small holes originally for in the hull? Will you be welding them closed with a bit of plate?
I just filled them internally as they were plated over externally already. I didn't make it very clear unfortunately. The working ones are to the right ,the old one on the left. Don't know why that was done originally.
Fishing is just an excuse for sitting by the water's edge, pondering the meaning of life. Catching actual fish is a distraction.
(This is my reasoning, and I'm sticking to it!)
Not a bad reasoning that, I do enjoy walking the bank with a spinning rod catching Perch & Pike.
@@nogunwales9406 It's my excuse for not catching any fish. 😉