Hi. Could you help me with this question? I am preparing to synchronize two generators. For this, it was advised to use avr Leroy Somer R450. Do I need to connect the analog output of the DSE8610 panel (0-5V) instead of a potentiometer (on the 1k ohm circuit)?
Hello, if you are using R450 you can use a bias signal from the DSE8610 to make the synchronization. Pay attention that you need to ensure the insulation from the DSE8610 side as the potentiometer input of the R450 is not isolated.
Hi.
Could you help me with this question?
I am preparing to synchronize two generators. For this, it was advised to use avr Leroy Somer R450.
Do I need to connect the analog output of the DSE8610 panel (0-5V) instead of a potentiometer (on the 1k ohm circuit)?
Hello, if you are using R450 you can use a bias signal from the DSE8610 to make the synchronization. Pay attention that you need to ensure the insulation from the DSE8610 side as the potentiometer input of the R450 is not isolated.
Do i have to start the Generator to do the programing or can i program it without installing the AVR
Hello, you can do programming without installing the AVR on the Generator