Hi, how dd you solve the issue. My installation is less than a month. I was not aware tht the power supply was off for a while until the garage door didnt wanna open nd when i switched it back on it started doin tht.
@@ntsatsieliasrabase9067 Agreed. One of the things missing in this video is that the charger only charges at 300ma. The motor is completely dependent on the batteries having enough charge to operate the door. So when the curtacy light is switching on and off it consumes more power than the charger can supply to recharge the batteries. It is a really bad design as you have no indication if the batteries are charged enough to operate the door. Disconnect the power on the motherboard then leave the batteries to charge for a few hours so that the motherboard does not consume any power off the batteries. Reconnect the power to the motherboard and then try your 5 run cycle when the batteries have enough power to complete 5 cycles else you would be stuck in a endless loop. The alternative would be to upgrade the batteries and power supply as mentioned. I would be cautious though to upgrade the power supply as these are lead assist batteries and they need to trickle charge. Over supply on current might lead them to swell and degrade.
Having the same problem and the courtesy light keeps flashing...
😁i am 2yrs late but i jst had this problem now (21 Nov 2023) and i ran the motor 5 times and the flashing stopped. i hope it helps :)
How ? Kindly explain
@@donovanmasoka7330 did you perhaps find a solution yet?
Thank you so much. I won after running it 5 times. But it was terrible. 😂😂😂
How do I stop the light from flickering like that??
Hi i had the same fault check the wires comimg from motor to the PC board whit plug make sure they make contact .
Hi, how dd you solve the issue. My installation is less than a month. I was not aware tht the power supply was off for a while until the garage door didnt wanna open nd when i switched it back on it started doin tht.
Hi Johan, Have you resolved this problem? I'm having the same problem.
Battery power lower. Let it charge. Then one cycle open close and back to normal
@@sivagounden i was also having that same problem
@@princemtandwachimanzi7088 diid u manage to solve this problem
Guys is there any one who manage to solve this problem because I also encounter it on a new installation
I am having this same problem. Motor is only 2months old. Battery's are still new . any ideas?
upgrade batteries to 7ah each , upgrade charger , then dipswitch 1 off also will work. I did that
@@ntsatsieliasrabase9067 Agreed. One of the things missing in this video is that the charger only charges at 300ma. The motor is completely dependent on the batteries having enough charge to operate the door. So when the curtacy light is switching on and off it consumes more power than the charger can supply to recharge the batteries.
It is a really bad design as you have no indication if the batteries are charged enough to operate the door. Disconnect the power on the motherboard then leave the batteries to charge for a few hours so that the motherboard does not consume any power off the batteries.
Reconnect the power to the motherboard and then try your 5 run cycle when the batteries have enough power to complete 5 cycles else you would be stuck in a endless loop.
The alternative would be to upgrade the batteries and power supply as mentioned. I would be cautious though to upgrade the power supply as these are lead assist batteries and they need to trickle charge. Over supply on current might lead them to swell and degrade.
@@hugoventer5856 my current charger is 28.8v 2A
@@hugoventer5856 Lifepo4 battery as well
Am having the same problem so how do I solve it
Let the battery charge fully then try ..
Am having the same problem does anybody have a solution
Run the door 5 times it will flash solid
Had same. It is low battery issue
Replace batteries
did you win on this problem
Hi