Thank you for this amazing tutorial, and also can you make a tutorial about how to light up another LED outside the built-in LED like an LED connected to a breadboard.
Hi, Thanks. I have an issue with the port COM, it doesn't show any available. I installed the CH341SER.exe from your link and from another external source. Not sure how to proceed. Do you have any other device? Thanks
i followed all the steps but still no port is coming up after selecting the board. I am using arduino 2.0.0 and is it normal for the red light to blink near the green main one marked L (near DIP switches)
Hello, thank you very much for your tutorial. I was successful in downloading my programs but once it is in my arduino, the program does not start. I do not understand
Grazie. Sono riuscitto finalmente a farlo funzionare. Bravissimo.
Thank you for this amazing tutorial, and also can you make a tutorial about how to light up another LED outside the built-in LED like an LED connected to a breadboard.
Did you find the solution?
How can I send data from ATmega328P to ESP8266?
Hi, Thanks. I have an issue with the port COM, it doesn't show any available. I installed the CH341SER.exe from your link and from another external source. Not sure how to proceed. Do you have any other device? Thanks
I know this Mans voice. robot on the waY SIR! *SALUTE*
Can you make a tutorial on how to use the Arduino Uno side of this Arduino like the ATmega328p.
very healpful. Thank you.
Is there a way to use the ESP8266 coding and still use the ports on the side of the ports and the not only those ones on the bottom?
i followed all the steps but still no port is coming up after selecting the board. I am using arduino 2.0.0 and is it normal for the red light to blink near the green main one marked L (near DIP switches)
How about OTA updates to firmware of ESP8266 and Atmega328 ?
unlike the arduino uno with separate esp8266, the atmega supports multiple analog input, am I right?
Yes
Followed your advice but I'm getting the error "could not open port, access is denied"...
Labai ačiu.
What size is the DC power port?
Hello, thank you very much for your tutorial. I was successful in downloading my programs but once it is in my arduino, the program does not start. I do not understand
Did you figure out how to fix that?
Great 😊
hmm it still did not work in my situation...
Tried this it did not work install failed.
Try using the latest versions, they do seem to work now. Although it should be working on the original versions too.
Thanks for the drivers. Windows now sees the board. I've set dip switches 5,6,7 but cannot upload. I get the following:
Uploading 223408 bytes from to flash at 0x00000000
.........................error: failed sending 1064 bytes
.....................................................error: failed sending 1104 bytes
.............error: failed sending 1059 bytes
..............error: failed sending 1059 bytes
warning: espcomm_send_command: didn't receive command response
warning: espcomm_send_command(FLASH_DOWNLOAD_DATA) failed
warning: espcomm_send_command: wrong direction/command: 0x01 0x03, expected 0x01 0x04
error: espcomm_upload_mem failed
error: espcomm_upload_mem failed
How about the wifi?
Coming in the next couple of days
Take a look here:
th-cam.com/video/2kKCHu7yw1s/w-d-xo.html