Mesa Dual Rectifier Multi-Watt - Hermansson Amplification

แชร์
ฝัง
  • เผยแพร่เมื่อ 28 ส.ค. 2024
  • This Mesa Dual Rectifier is modified by Hermansson Amplification. The red and orange channels have the Hermansson 4 gain stages circuit.
    The distortion is tighter, the dynamic response is increased and the overall noise floor is reduced. The layout is changed and shielded cables are installed to improve the signal-to-noise ratio. I've integrated my tightness control with the gain controls for the orange and red channels so the voicing follows the gain sweep. The clean channel is changed to sound more open and the layout is changed for this channel as well so you can turn treble and gain all the up in push mode without oscillations, it also has more gain available.
    Guitar straight into the amp, TC D-two in the loop.
    Make sure to subscribe to this channel and check out my Facebook page: hermanssonamplification

ความคิดเห็น • 21

  • @sebastiengregoire4179
    @sebastiengregoire4179 10 หลายเดือนก่อน +5

    Holy!!! A monster... That sounds so impressive

  • @jerryvargas268
    @jerryvargas268 10 หลายเดือนก่อน +2

    UNBELIEVABLE ‼️‼️

  • @jasoncrump1886
    @jasoncrump1886 10 หลายเดือนก่อน +1

    Man I'd love to have one.

  • @DJ33
    @DJ33 10 หลายเดือนก่อน +2

    Wow …holy sustain !

  • @risonbison7207
    @risonbison7207 10 หลายเดือนก่อน +5

    can you start miking the cabs up so we can hear it better?

    • @LordFingers1
      @LordFingers1 10 หลายเดือนก่อน

      it sounds amazing. no need to mic the cab!!! viva la hermansson!!!

  • @msaintpc
    @msaintpc 10 หลายเดือนก่อน +1

    Sounded good my brother.👍

  • @RezaMatix
    @RezaMatix 10 หลายเดือนก่อน

    some great tones and playing here🎸🤘🏼🎸

  • @guidedbyechoes
    @guidedbyechoes 10 หลายเดือนก่อน +2

    When you do your changes do you make mods to improve the amp, or do you basically redesign the amp from the ground up? Because your designs clean up so well most people could do entire gigs with one channel and a volume knob.

    • @HermanssonAmplification
      @HermanssonAmplification  10 หลายเดือนก่อน +2

      I install my own preamp designs in the amps I rebuild. I always need to change some internal layout in the amps and install circuits above the PCB, install shielded cables etc.
      So I use the amps as platforms for my own circuit designs.

  • @cosmicsoulsofficial
    @cosmicsoulsofficial 10 หลายเดือนก่อน

    awesome sounds! greetings to sweden!

  • @GigaManners
    @GigaManners 10 หลายเดือนก่อน

    Peak tone

  • @khalez1471
    @khalez1471 10 หลายเดือนก่อน

    I luv it.

  • @fjunigapresten
    @fjunigapresten 10 หลายเดือนก่อน +1

    What are these guitar cables you are always using?

    • @HermanssonAmplification
      @HermanssonAmplification  10 หลายเดือนก่อน

      I make these cables for my personal use, silver plated cables with super low capacitance, FEP jackets, rated at 200C° and 900V RMS. So you can say it’s more of a laboratory cable than a normal guitar cable 🤓

  • @haiderman1610
    @haiderman1610 10 หลายเดือนก่อน

    Which guitar are you using here?

  • @lookformeinthewaves
    @lookformeinthewaves 10 หลายเดือนก่อน

    I’ll take the one on the bottom 😂

  • @msaintpc
    @msaintpc 10 หลายเดือนก่อน

    I have three Mesa Dual Recs, and nice amps they truly are. But any Marshall JCM 2000 DSR will blow them out the water. Even the new Chinese Marshall DSRs will blow the Mesa away.

  • @FuturoAnacronico
    @FuturoAnacronico 10 หลายเดือนก่อน +1

    Mr Badass Ampmaker!