S10 LS SWAP PT 15: Converting to AN TRANSMISSION Cooler Lines

I lost my original transmission cooler hard lines and decided I would switch over to AN lines. This involved adapting the 4L60E over to AN fittings and then making the lines for them. My transmission crossmember was also modified to allow for my exhaust to flow through without having to make any awkward bends or turns.

[@coyoteserranoband]

Have so many fittings because of you. I'd like twenty radiator to transmission line fittings...

[@ItsyaboyR.B]

Nice build💯...s10 or silverado obs gonna be my next budget build.

[@urpi9434]

0:35 so what I'm hearing is you, in fact, do NOT want your exhaust to double as a skid plate...? 🤔

[@WOTGarage1]

Lol negative ghost rider

[@Beuwbsldurbdk]

Great video! So did you end up not wanting to take out the stock fittings on the transmission? When u got the new fittings it looked like the original hard line fittings were still on there.

[@WOTGarage1]

The hardline fittings in the transmission were replaced with fittings that would adapt to the -6 AN lines that were being ran.

[@MechanicalDrifting]

On the an fittings going to trans did you use a oring or any type of washer ?​@@WOTGarage1

[@coyoteserranoband]

Where'd you get all these parts? I have struggled for months...

[@alexaustin4581]

Where did you get the part from did you put in the side of the transmission I need the part number

[@davidconley3610]

Put a LS-6 intake on it. That should eliminate the heater hose problem and look better too!

[@WOTGarage1]

Agreed, but I already purchased the TBSS I take and it is one of the best intakes from GM, so I figured I’d make it work

[@74mythos]

Yea the ls6 intake isn't the best option, the TBSSS intake is the better flowing intake.