I have a 2011 Hino 268 Hydraulic Disc Brakes. Truck is slow from a stop. Only after its warmed up. No fault codes logged. 1st and 2nd gear are slow. Accelerator pedal says 50% throttle when pedal all the way down. Then in 3rd gear it lets it rev back up to speed. Neutral and park it allows you to go full throttle.
Thank you for these very helpful videos! I have a problem with my 2017 Hino 268A I think it runs lot slower than other 268’s specially on the hills and also it struggles a lot to reach 65 mph on the highway. HK Dealers in Edison NJ already replaced the injectors and took away the check engine light code. I adjusted the sensor on the brake pedal however the truck stills feels week to me when taking off or on the highway. I feel disappointed. Any suggestions would be highly appreciated ! Thank you !!
I realize this is an old thread, but I’m having a very similar issue. Truck starts, idles and revs up just fine, when you move and it recognizes vehicle speed it bugs down dramatically, and dies. Starts right up and same issue again. I looked at this sensor and wires and it doesn’t look like any damage, I’m at a loss 😢
Hey my friend i have same problem with my hino 2009 drive good but at time the truck lose power like run out of gas just replace turbo still having same problem no check lights
@@truck_diagnostic hey I have a 2012 fm 2630 with Alison At, abs light is on and has disabled exhaust brake and truck is over reving in each gear and not going into over drive I have a bill of 4K now with my local hino, they have plugged diagnostic into has no fault codes , they orders a new abs module and tried that and no good also 2x electricians, I’m stuck any help would be greatly appreciated willing to pay $$
Let me know how you can be reach . 2010 Hino 268/258 goes normal up to 45 mph but by then the pedal it’s already all the way down so I have to let go and step back on it to go above 45mph . No lights on board
My 2009 Hino 145 no power when at complete stop then it picks up after i let off throttle and press again. Does not have air brakes. I changed the throttle body and still. Please help
Hey bro. My hino 268 2013 model has a problem similar to. It goes slow when i break to stop and then until 30-35 the it takes like nothing happened. Do i get chaked the same thing?
I’ve been dealing with this problem for about a year now..Ive changed the Senors and also made sure the wires are not broken and my truck is still doing it I can’t pass 5mph
I have the same problem with my 2005 hino 268 but I don’t have that switch or I can’t see it, this problem started 2 weeks ago and now it doesn’t go pass 40mph and 2rpm. It has no power at all.
Try to scan the code maybe has a inactive codes from there we can try to figure out but most problems loosing power air filter , turbo, fuel filter , egr valve I'm not sure if u truck has , and common rail last thing trans if u have abs light on will have problems too
Hello my friend I’m having the same problem can you please help 2013 Hino 268, no power when trying to Accelerate after slowing down, then after 10 seconds the power comes in an we accelerate. Can you please help
Hey man I need you help with the same situation I replaced the brake switches by the paddle I replaced the brake hydraulic booster and turbo . Still losing power when accelerating but once I reach 20 mph and drives just normal . I will pay for the information please how can I reach you
Thank you for all the help
Have a Hino in the shop with this exact problem. They had to bring in a Hino Canada rep to figure this out. Wish I seen this video 3weeks ago!!!!
👨🔧👨🔧👍👍👍
I have a 2011 Hino 268 Hydraulic Disc Brakes. Truck is slow from a stop. Only after its warmed up. No fault codes logged. 1st and 2nd gear are slow. Accelerator pedal says 50% throttle when pedal all the way down. Then in 3rd gear it lets it rev back up to speed. Neutral and park it allows you to go full throttle.
It turned out to be the brake switch. Hino suggests replacing the brake pedal return spring and adjusting the brake switch.
Thank you for these very helpful videos!
I have a problem with my 2017 Hino 268A
I think it runs lot slower than other 268’s specially on the hills and also it struggles a lot to reach 65 mph on the highway. HK Dealers in Edison NJ already replaced the injectors and took away the check engine light code. I adjusted the sensor on the brake pedal however the truck stills feels week to me when taking off or on the highway. I feel disappointed. Any suggestions would be highly appreciated ! Thank you !!
Don't have more codes most problems on the truck is fuel restrictions exhaust brake stuck and turbo sticks on the leakage
I realize this is an old thread, but I’m having a very similar issue. Truck starts, idles and revs up just fine, when you move and it recognizes vehicle speed it bugs down dramatically, and dies. Starts right up and same issue again. I looked at this sensor and wires and it doesn’t look like any damage, I’m at a loss 😢
Hey my friend i have same problem with my hino 2009 drive good but at time the truck lose power like run out of gas just replace turbo still having same problem no check lights
Thanks for the vid
My fe2620 with an Allison AT. Exhaust brake stopped working. I'm gonna look into this scenario...
If u have abs light on
Exhaust brake will be disable
@@truck_diagnostic hey I have a 2012 fm 2630 with Alison At, abs light is on and has disabled exhaust brake and truck is over reving in each gear and not going into over drive
I have a bill of 4K now with my local hino, they have plugged diagnostic into has no fault codes , they orders a new abs module and tried that and no good also 2x electricians, I’m stuck any help would be greatly appreciated willing to pay $$
@@michaelmackellar7072text me on instegram as @truck_diagnostic
Can't find you on telegram
Wow
Let me know how you can be reach . 2010 Hino 268/258 goes normal up to 45 mph but by then the pedal it’s already all the way down so I have to let go and step back on it to go above 45mph . No lights on board
I HAVE A HINO 268 W/O AIR BRAKES AND HAVE THIS SAME ISSUE IS THERE A SWITCH SOMEWHERE UNDER THE TRUCK LIKE THIS ?
My 2009 Hino 145 no power when at complete stop then it picks up after i let off throttle and press again. Does not have air brakes. I changed the throttle body and still. Please help
Whats the part number for the brake switch?
we have an abs on 2000 Hino 1817FB on hints on how to start diagnostic
Please and thank you>
Where are you located
Hey bro. My hino 268 2013 model has a problem similar to. It goes slow when i break to stop and then until 30-35 the it takes like nothing happened. Do i get chaked the same thing?
We have hino truck when brake apply it working on very low position of pedal what is the problem pls
wabco right rear abs valve open corcuit what yo do
Hino 700 power is off whats the problem
Hi boss I had same problem air assisted hudraulic brakes brake paddle a kind of every time at signal I have to lift with leg
I’ve been dealing with this problem for about a year now..Ive changed the Senors and also made sure the wires are not broken and my truck is still doing it I can’t pass 5mph
Eassy to fix where u at
Having same problem 2006 hino 268
How I look for that switch mine is having the same problem wont go pass 50mph and I found that switch is broken what is call
What switch 😢can u tell me i am struggling rite now on the freeway pls let me know God bless you guys
Tengo un problema pareciodo
Let me know
Hi I have a 2012 Hino 268 the check engine light comes on around 45 55 mph. And the truck won’t go pst 45 any idea please?
Fuel pressure or turbo under boost
I have a 2011 hino 338 my truck its alway running slow its drive like it load at all time
I have the same problem with my 2005 hino 268 but I don’t have that switch or I can’t see it, this problem started 2 weeks ago and now it doesn’t go pass 40mph and 2rpm. It has no power at all.
Check the code first can be the turbo
@@truck_diagnostic it have no code at all and turbo sounds good
Try to scan the code maybe has a inactive codes from there we can try to figure out but most problems loosing power air filter , turbo, fuel filter , egr valve I'm not sure if u truck has , and common rail last thing trans if u have abs light on will have problems too
Hi there, I have similar issue with mine, a month has passed still no solution
Let me fix the issue
Did you fix it
I don’t have a diesel Bawar in my truck it’s a HINO Trucks 2014
Hello my friend I’m having the same problem can you please help 2013 Hino 268, no power when trying to Accelerate after slowing down, then after 10 seconds the power comes in an we accelerate. Can you please help
Sure
Did you found the problem ? I have the same problem
@@alonsoguzman3226 yea I did DM your number so I can speak to you direct it’s a long explanation
Hey man I need you help with the same situation I replaced the brake switches by the paddle I replaced the brake hydraulic booster and turbo . Still losing power when accelerating but once I reach 20 mph and drives just normal . I will pay for the information please how can I reach you
@@Tawan14159 dm your number to see if I can explain it was a lot
I pay you for your expertise face time
Look for me on Instagram and text me