Setup Auto Focus Parameters for Ruida controlled Laser
ฝัง
- เผยแพร่เมื่อ 13 มี.ค. 2022
- This is an instructional video of how to set the auto focus parameters for an OMTech Ruida controller through the use of Lightburn. In other words this video tells you how to adjust your focal length when you run the auto focus program on an Ruida controlled OMTech or Monport laser.
More info on the differences between manual focus (mf) and autofocus (af) can be found here
www.oeadesignworks.com/focus
OMTech Websites
OMTech US Site - Save 5% on entire cart & free shipping use code ---- oeadesign5off
omtechlaser.com/oeadesign
OMTech Canadian Site - Save 5% on entire cart & free shipping use code ---- oeadesign5off
ca.omtechlaser.com?sca_ref=2643218.wc0VlHACkY
OMTech UK Site - Save 5% on entire cart & free shipping use code ---- oeadesign5off
omtechlaser.uk?sca_ref=2643262.lbN8ygLN4I
My Website - Navigate to OMTech Laser section at the top (feel free to check out my site too)
www.oeadesignworks.com/omtech...
Rotoboss Website, use my affiliate link below and
Save 5% on entire cart use code - oeadesign
rotaryattachments.com/?wpam_i...
SpeTools Website
Save 10% on entire cart use code ---- oeadesign
spetools.com/?ref=OEADESIGN
Discount Code "OEADESIGN" to save 10% off your entire order - แนวปฏิบัติและการใช้ชีวิต
Exactly what i was looking for. Just got my AF2028-80 today, and will be getting it setup this weekend. Thank you!
Glad I could help!
you have your z axis setup on your u axis settings? or is up and down not called the z axis on lasers? i have mine all physically wired but its kinda a nightmare to setup the software when you know nothing about them. this is my first co2 laser. omtech 55w. just added nema 23 425oz and DM556T controller to my z axis belt. the ruida controller goes up and down just fine through the ruida but the autofocus button doesnt do anything at all..
the vertical axis is typically the z or u axis. it depends how the machine was wired. mine is set up on the u axis.
I have a question for you i have the same laser you have here.. how do i get my control panel Arrow keys to move around 🤔 also my bed to move up n down. I set something up wrong n my control panel..
Not sure exactly. Are you saying your arrow keys don't work? Does you screen say continuous or jog? If it says jog press the button in the center of the arrows one time. It should then say continuous and the arrow keys should work
I followed your instructions changed my home offset 2mm but when I hit autofocus it never changed it. It was 0.0 I input 2.0 after write & ok it did not change it.
I have the ruida RDC644XS which when I look it up on the internet not able to find it.
On mine I chane the U settings. You may have the change the home offset under the Z settings.
@@oeadesignworks I'll give it a try, thanks
No problem
How do I wire it ?????
did you watch/follow the video?