Anycubic Chiron Direct Drive Conversion

www.thingiverse.com/thing:431...
Made two changes.
Used capricorn tubing instead of brass fitting. I made sure it was tight by removing the plastic part that it sat in in the extruder and inserting the properly cut tube into the part before reassembling the extruder.
Used 3 screws to hold the assembly to the fan shroud instead of 4 due to one of them being close or under the circuit board and me trying to change as little as possible from stock.

[@xxxratixxx]

Good vid hope to see more soon and what mods your going too add