Alfa Giulietta Trunk Won't Open, Testing and FIX, Boot Trim and Lock Removal

แชร์
ฝัง
  • เผยแพร่เมื่อ 29 พ.ย. 2024

ความคิดเห็น • 43

  • @nickmiles-plummer9773
    @nickmiles-plummer9773 2 หลายเดือนก่อน

    Best video out there on fault finding the Common boot lock problem on the Alfa Giulietta.... Excellent photography n explanation

    • @arcgarage
      @arcgarage  2 หลายเดือนก่อน

      Thanks man

  • @ovidiunaso5639
    @ovidiunaso5639 8 หลายเดือนก่อน +2

    Same problem had my neighbor's 2010 Giulietta, I fixed it and looks like it was old problem because some not so qualified person fixed somehow the wires before. Thanks for help.

    • @arcgarage
      @arcgarage  8 หลายเดือนก่อน

      No problem, glad you solved it

  • @simonattwood6100
    @simonattwood6100 ปีที่แล้ว +3

    Had the same problem with my Mito. After a bit of trial and error, turned out to be a broken wire in the side column of the hatch. I managed to put it through and fix. and feed it back in. Was a fiddly job!

  • @Easy2take
    @Easy2take ปีที่แล้ว +3

    Nice and in depth diagnosis. Also FYI if you ever need to replace the trunk lock you can look for one from opel astra or opel corsa as they are the same, just make sure you got matching part number, and locks from opel are way cheaper.

    • @arcgarage
      @arcgarage  ปีที่แล้ว +2

      Thanks for the info

  • @red75v67
    @red75v67 ปีที่แล้ว +1

    Need to do the same job on my 147. Looks like a pain but I suppose once the boot is off it shouldn't be too bad.

  • @bldriver7453
    @bldriver7453 ปีที่แล้ว +1

    0:58 , I was thinking - looking at those two screws, maybe you should put a washer in between the screw and plastic itself.
    Its just, the way it looks, I have the feeling that plastic will break right there eventually because only a small part, the edge, of the screw is gripping on to the plastic.
    From all the driving, bumps and holes in the road, I feel it will eventually break.
    Especially the one at 1:03, look at the left side of the screw, its barely gripping the plastic

    • @arcgarage
      @arcgarage  ปีที่แล้ว +1

      Did it when I was returning the trim piece, but thanks for concern

  • @paulfitzgerald7290
    @paulfitzgerald7290 ปีที่แล้ว

    Excellent video. Perfectly explanation.
    Do you have any insight on why the disconnect does not start up.

    • @arcgarage
      @arcgarage  ปีที่แล้ว

      Thanks, sorry I don't understand the question

  • @ramirajeh
    @ramirajeh ปีที่แล้ว

    I want to say that everything you mention about faults and common problems with the GIULIETTA model is spot on. Your videos really help giving insight into my Alfa Giulietta. I wish your garage was in the country where I lived!
    I have a Giulietta 1.4 petrol (VIN ZAR940000 07111581, engine 940A2000, Year 2012) and my dashboard acts like there is a ghost in control. It changes languages by itself; it dims and sets speed limits by itself; it changes the date and time, and various other settings change while the car is on. Do you know why this happens, what needs to be fixed/changed? A local electro-mechanic said I need to change the BCU & ECU & Key. Have you come across this issue? Thanks in advance 🙏

    • @arcgarage
      @arcgarage  ปีที่แล้ว +1

      I would have to test it to give you a good answer

  • @mrcaps1971
    @mrcaps1971 ปีที่แล้ว

    Another great and useful tutorial. Thank you

    • @arcgarage
      @arcgarage  ปีที่แล้ว

      You're very welcome!

  • @NickSaliaras
    @NickSaliaras ปีที่แล้ว

    Thanks for sharing this video!
    My giulietta's boot is opening with the fob but not with the button(I've tried a new button and a new lock but still not working, you reckon is the wiring loom?
    Many thanks,
    Nick

    • @arcgarage
      @arcgarage  ปีที่แล้ว

      You're welcome, could be, check to see what is going on

  • @dusankocisevic6823
    @dusankocisevic6823 ปีที่แล้ว

    Dobro urađeno, kao i uvek👊👊👊

  • @deanusrjm
    @deanusrjm 5 หลายเดือนก่อน

    I have a similar problem with my Alfa Gt. Tested the plug with a test light and one pin lights up when the key button is pressed on one pin but nothing on the other pin. Does this mean that the wiring is bad? I tested the lock and actuator and these are fine.

    • @arcgarage
      @arcgarage  5 หลายเดือนก่อน +1

      No, make sure you know how to test the ground as well

  • @jacobpaulsen3308
    @jacobpaulsen3308 ปีที่แล้ว

    HI THERE...I OWN A 147 2.0 L TSPARK THAT HAS A INTERMITTENT LIMP MODE ISSUE AND MOST RECENTLY I EXPERIENCED A MISS FIRE. Do you happen to have any idea as to what can cause it? I REALLY NEED HELP ON THIS !!

    • @arcgarage
      @arcgarage  ปีที่แล้ว

      Check the coils, and use diagnostic tool to check out everything else that could cause the issue

  • @bldriver7453
    @bldriver7453 ปีที่แล้ว

    Very well done.
    I wanted to ask you again, do you have few minutes to take your iDiagnostics ELM adapter apart and snap few photos of PCB that is inside it ?

    • @arcgarage
      @arcgarage  ปีที่แล้ว +1

      Saw the email, as soon as I get some time I will do that

    • @bldriver7453
      @bldriver7453 ปีที่แล้ว

      @@arcgarage Oh my god thank you so much, it really means a lot.
      All I am looking for is one clear photo of the whole PCB and few close up photos of chips.

  • @joemaster986
    @joemaster986 ปีที่แล้ว

    Jel radi sad i na dugme pozadi? Reče na početku videa da nije hteo ni na dugme. Moj ne otvara na dugme, ali hoće na ključ, pa me zanima da li si možda gledao kako je vezano dugme, ide li nazad do razoda ili prespaja odmah 12V na bravu? Pitam da se ne mlatim bezveze da sam pokušavam, jer ako ide nazad na razvod to mi je komplikovano, al sa sa dugmeta na bravu bih relativno lako našao koja žica ne baca i sredio to sam.
    I lepa ti je Alfa! I ja sam hteo crvenu, al na kraju ipak dođe siva (MA varijanta od 170ks)

    • @arcgarage
      @arcgarage  ปีที่แล้ว +1

      Ako se sjecam dobro, mislim da dugme ne ide direktno na bravu, ali nisam siguran, hvala

  • @DooMSandro
    @DooMSandro ปีที่แล้ว

    *_Amazing Video again, ty for your help!_*
    *_Question:_*
    *_Do you know/have a video, how to change the radio antenna cable?_*
    *_I have a Giulietta and my Father a MiTo, and his reception not working...we tryed 3 different radios, but nothing is working._*
    *_Now we believe that the cable or the antenna is defective and would like to change it_*
    *_Do you also have a purchase recommendation, which antenna cable is compatible with a MiTo?_*
    *_Have a nice day :)_*

    • @arcgarage
      @arcgarage  ปีที่แล้ว +2

      I will actually do a video on that soon

    • @DooMSandro
      @DooMSandro ปีที่แล้ว

      @@arcgarage *_Wow amazing, perfect! 😍🙏🏼_*

  • @shroomssoft
    @shroomssoft 8 หลายเดือนก่อน

    Hello do you know which fuse i n the fuse box is for boot .

    • @arcgarage
      @arcgarage  8 หลายเดือนก่อน

      I don't think it has a dedicated fuse, but I would have to check just in case

  • @mire5953
    @mire5953 ปีที่แล้ว

    Just discovered problem with my GT and opening trunk. It won't open on keyfob or button inside. I can hear click under steering wheel when pressing button. Windows are working, fuel flap is working button fine. Any advice?

    • @arcgarage
      @arcgarage  ปีที่แล้ว

      You can use this same method to diagnose the issue

  • @GeorgiosGeorgiou
    @GeorgiosGeorgiou หลายเดือนก่อน

    How do we call that screwdriver ?

  • @ivo2410
    @ivo2410 ปีที่แล้ว

    Hey ,u know how to reduce fuel consumption to a giulietta ?

    • @arcgarage
      @arcgarage  ปีที่แล้ว

      How much does yours take?

    • @ivo2410
      @ivo2410 ปีที่แล้ว

      9-10 mixt

  • @ivajloatanasov490
    @ivajloatanasov490 8 หลายเดือนก่อน

    Всичко е много добре направено, но...по Ел. инсталация на кола не се запоява с тинол. Най- добре е твърда, пресова връзка. Предишният път пак е била на спояване и се е прекъснала. Проблемът е, че колкото и добре да е изолирана спойката, все пак попада влага и се получава галваничен елемент. Припоят се разпада и връзката се бламира.