2014 GMC Acadia front bumper removal

[@larryf2440]

Great video. Brings back the old VW, had to pull the engine to replace 50 cent switch. Thank for your time

[@j-flow617]

Thanks for watching!

[@Adonis.TheGod]

Thanks J-flow, you're awesome! 👍🏼

[@nickfladhammer793]

Great Video man. Thanks!

[@Albert_G_Gunz]

Thanks for taking the time to film this brother 💪

[@bflynn1985]

I need to replace that decorative bezel below the headlight. It is held in by 2 screws from behind. How ahould i go about that? (Hit a tire i couldnt avoid on the interstate)

[@AlfonzoDupree]

Order on line they snap in you have to remove wheel swash covers other wise u will damage them

[@KayHillFashion]

Thanks for the video, will be doing this later on today

[@angiehaberichter7146]

do i have to take off the whole bumper to replace the bottom two pieces?

[@j-flow617]

Yes, most likely theres something keeping it attached to the bumper, like a clip holding it or some screws.

[@frankyost7852]

Thanks. Nice job.

[@j-flow617]

Thanks for watching!

[@MrRamair17]

Will a 2nd gen bumper fit 1st gen?

[@j-flow617]

Never done it before, I’m not sure

[@dofo6842]

Thanks for the video can I just loosen one side to get the headlight unit out? Or should I just take the whole bumper out? Thank you. Saving me money to replace DRL ballast $50 part vs $500 if I take it in.

[@dofo6842]

Ok I did it I change the DRL (Daytime Running Light) ballast. So i followed every step but I only did it on one side (Headlight that I need to work on) I pop the bumper off to get access to two 10mm bolt I need. Got it all done save me $800ish for $50 DRL Ballast. There are 2 ballast for the headlight the one for DRL and the one for High/Low beam light. Thank you again with this video. Blessings.

[@j-flow617]

Nice!

[@djlyfe557]

Good video Bro.

[@j-flow617]

Appreciate it!

[@codyallen5197]

Good video 📹

[@j-flow617]

Thanks for watching!

[@ygfromig]

how do i take off the fenders

[@j-flow617]

TH-cam it bro

[@jasminehernandez365]

I’m reality time, how long did this take you?

[@j-flow617]

For me 10 mins or less but I do it everyday. For the average joe, maybe 20-40 mins if you learning. Just take your time so you don’t break anything

[@Av8orDave]

So glad I have to take the entire front bumper off just to change the headlight assemblies...

[@j-flow617]

I’m glad my video was able to help you!

[@michaelrobinson3473]

Where are you located (country)?

[@j-flow617]

America.

[@ygfromig]

@@j-flow617 which one?