Audio King Professional Power Amplifier Restoration // Restore And Reuse Old Damaged Amplifier
ฝัง
- เผยแพร่เมื่อ 3 ก.พ. 2023
- Audio King Professional Power Amplifier Restoration // Restore And Reuse Old Damaged Amplifier
Restoring the burnt-out amplifier is my job today. This Audio king amp looks new from the outside, but it's pretty badly damaged, I have to spend a lot of time looking for parts to repair. replacement.Finally, the restoration and repair work has been completed.The recovery video has many shortcomings, looking forward to suggestions to improve in the next videos...thanks
Thanks for watching!
Please Like, Subscribe & Share!
► Subscribe to channel: bit.ly/3rbyDny
►More video Restore & Restoration: bit.ly/2PO241N
• Restoration Original O...
• Manual Restoration Of ...
• NEC AV 300 PRO Ampli...
• Antique Technics Audio...
• Restoration Kenwood St...
#Restore
#Restoration
#Audio
#Amplifier
#Reuse
![CAMPปลิ้น | EP.76[1/2] โจโฉเปิดป่าโหดรับโอ๊ต-ป๊อบ รอบนี้พี่เอาจริง!](http://i.ytimg.com/vi/pNg5O7Pf-a0/mqdefault.jpg)
Old is gold.
Nice 👍👌👌 04/02/2023 🇮🇳
Поздравляю Вас Мастер Справил Авдио Усилитель Звука Мастер На Все Руки Удачи Тебе Блогер
...//
The video is up. Subscribed and hit the bell. I think the same approach to repair prmmenit. Then immediately everything that does not burn out properly and you can visually assess what to change. Like 😎
Hasta acá olió a humo!
nice video Tnhanks..
Great job 👏👏
Hello. If you turn on the amplifier for testing, I advise you to turn on the amplifier through an incandescent lamp connected in series with the amplifier. If the amplifier is defective, the light will illuminate and protect the amplifier components from fire. After repair, the first inclusion must be carried out through an incandescent lamp, so as not to re-repair and understand that the amplifier has not yet been repaired and there are problems in it.
And he says he is professional. By turning it on before really looking inside of it, especially on such a corroded device, it very licely to damage more than needed.
yes...//
Не в коня корм, тут сплошное надувательство в этом кино.
@@rusab5130 jojo, pro efekt připojil kondenzátor na nízké napětí a ten po chvilce explodoval.
Это ж было шоу)
Esto va para largo
The amplifier was smoking before he switched it on and the left knob fell and started smoking
😇😇..🤔🤔
Hater
Pro 🤩
I can’t believe any audio engineer would replace so many components after stripping the chassis then reassembling with the lid on and just switching on, that is just looking for an explosion 💥
Good job...
Todo intacto
Super work
thank you..
Y continuamos
Lo mejor
I love the amount of love and dedication you show on these restorations!
Thanks
@@khoitran4033 bb h fee aSS REALLY U✔️✔️
Tôi rất thích cách làm như thế này
Thanks very much . We will try in the next videos
O man,, you got the spare parts from a mountain of junk ... Like fishing in an ocean ..
...?? yes
@@restorerestoration4705 keep your spare parts organized ...
Morning sir saan po location nyo kc may ipapagawa po Akong kenwood amplifier model ka-v9500 sanapo mabasa nyo at masagut po Ako salamat
viet nam...
Да, ремонтник ещё тот... Долго они ещё будут вводить в заблуждение ради хайпа. Кто понимает в радиотехнике, тот поймёт
Я за два года до хера насмотрелся на ютубе таких "реставраций" Калечат технику, обезьяны проклятые.
@@belochegman 😂
конденсатор перевернул переполюсовка для эффекта))) 🤣
headache..😃
Не сомневайся....
Lo dejas como nuevo
Радует паяльник и мультиметр. А ещё классный передник на шефе. Мне кажется он диэлектрический. Так держать! 👍🏻😊
yes
А ещё - уверенность в дефектации. Про подбор деталей я умолчу.
Like a vietna-am
👌👌..
Việt Nam mito
Es chévere
A seguir
Maestro de maestros
Audio king台灣撼聲電子創立于1977年，主要為專業主機、歌唱用專業喇叭...MADE IN TAIWAN IS GOOD.
Fabuloso
Why you did not use a Safety Bulb to Ac line for protection
yes...thank you
because they specifically connected it so that there was a fire show for the video
@@brainwayOf ok like mr. Electro boom does it.. cool
@@brainwayOf hihi...😇😇
hol van a fi relé, hogy zárlat esetén azonnal leoldja az áramot? vagy az is direkt meg van patkolva
látvány miatt?
เข้าใจทำคอนเทนท์นะ
Thank you very much . Please always follow and support us!
Good job 👍👍
yes..
Такие гениальные люди могут даже собрать с гавна и палок вертолет!
💣💣💨💥💥
Para comprobar si funciona
No juegues amigo, porque no le pones un foco en serie
yes..
Классно восстановил! Истинный мастер!!! А какова выходная мощность этого усилителя?
Cудя по напряжению питания оконечника и количество транзисторов в параллель, Ватт 150 на 4 Ома номинала.
Una buena pintura
Lo máximo
Este amigo es sorprendente
Obrigado amigo
Sorprendente
Fireworks, that's not real magic smoke
🤔🤔...??
Los amplificadores son excelentes
yes..😃
Q111Jqq
Q111Jqq
Magnífico
110/220
Manos a la obra
yes..
Well that's the problem when you let the smoke out!
eu gosto quando explode ahahaha
Obrigado amigo
@@khoitran4033 i said i like when it explodes lol. thanks
🤔🤔....Noo....
❤❤❤❤ phát tài
Fantástico
the comments about up in smoke and going thru so much work. Well I say this. sure you could have taken short cuts but stripping it down completely isn't that much more work anyway. you get to clean everything use all new screws re-paint ,give it a face lift. all those caps needed to be changed anyway, new bridges are cheep. It's a nice amp I think its a job ŵell done
Awesome, great job! 👍 love your videos!
Liquid is >>
Esse deu trabalho, faltava botões, as pistas ressecadas. Quanta dor de cabeça! 🤕
Felipe Si 👍
💪🏻💪🏻💪🏻
good job on the restore!!
Поздравляю ,надо было обязательно без проверки включить и спалить плату ? Грош цена такому "мастеру" .
After open and that fuse only is broken😎
yes...🤔🤔🤔
@@restorerestoration4705 no , I'm jokes sir😁
Well done my friend. Thanx. Ken from gpt ms
Magic Smoke
❤❤❤❤
wow that power board sure did smoke out fast, it really is to bad there isnt a way to have toe components PROTECTED some way before the component dies
yes...
There is xd
Está muy oxidado
Asombroso
That paint job... OMG
Мне не понятно для чего надо палить усилитель?
Could you tell me how do you troubleshoot electronics circuits when it doesn't work?
Таким паяльником только полевики паять😂😂😂
Полярность конденсаторов нужно соблюдать, ужас какой-то!дизлайк
yes...
helow my prend
Thanks very much . We will try in the next videos
Okh.🙏🤚
Fantástico!!!!!!🤗🤗🤗🤗
какая фантастика? Обычный фейк и петарды.
A few tips: use thermal pads instead of that shit white paste. With a thermal pad you dont need that piece of insulating plastic. With this old equipment always check the fans bearing. Its possible, that they dried out. In my opinion, they belong to the recycle bin and replace them with Noctua Flex fans. They come with the 2 pin adapter. They are much much more quieter, than the original stock fans(i have a Technics SA-TX50 with Noctua fan).
Muito bom 👏👏
Actually the last part of the video is the first when it worked...The first part of the video is after he fooled with it and burned it up!!!
4:23 непонятно
...
Зачем всё разбирать.... 00:01
К_контент, капец.
К_контент, капец.
Ага капец
как набрать просмотры...
Взрыв хорошего усилителя... За15 сек
th-cam.com/users/clipUgkxLk5krJoFcA-f7Wxz-GTMAthNVW7o3l8c
π
Паяльникам забить можна
Why would you turn it on before testing?
Parte por parte por parte por parte por parte por parte por parte por parte por parte por parte por parte por parte por parte por parte por parte por parte por parte por parte
Bg klok IC beda no gc pp kan.
Thank you very much
Лютейший бред
That was the nicest thing called repairing...🤣🤣🤣
а фиг трафф демонтировал? и паяльник ужасс
A trabajar
yes..
Get a digital multimeter 😀
Siempre explotan igual .
....... Raro
Should have used a 100W bulb in series with mains🙄
😢
Ну паяло у кадра это аж трындец. Только бычки от него прикуривать.
Arızalı bir cihazı,arızalı olduğunu bile bile elektriğe takmak büyük aptallık...It is very stupid to plug a faulty device into electricity even knowing that it is faulty...
Ngủ nhỉ !!!!!!!
Deixa de ser besta ele ligou pra que queime logo o que tem de queimar pra ele ajeitar de uma vez por que si não ligar vai queimar de novo
yes...
👏👏👏👏👏👏✌✌✌✌🇧🇷🇧🇷🇧🇷🇧🇷🇧🇷
😳👍❤️🌹🌹👌
Alimentare dalla rete un dspositivo evidentemente andato in acqua senza prima verificarne lo stato dei circuiti e l'isolamento, e senza interporre una opportuna protezione/ limitazione di corrente corrente Porta di conseguenza a determinarne un esteso ed ampio guasto che invalda il tentativo di recupero del dispositivo! Tradotto con google traslate :Powering a device that has evidently gone into the water from the mains without first checking the state of the circuits and the insulation, and without interposing an appropriate current protection/current limitation This leads consequently to determining an extensive and extensive fault which invalidates the attempt to recover the device !
Muy brutos los técnicos o fue de adrede
what a joke. It's already smoking before they switch it on the first time, then the rear board shifts in the cut between it starting to smoke and then the caps going violent. Oh man, they've got wire nuts on the input and the trafo wiring, this is fake
...there is confusion
1111111171117
11711111111
Los condensadores fe filtro, al carajo....
Sigamos viendo.
another not up to the repairman. why disassemble everything when it was necessary to work with a diode bridge and capacitors at the input of the power supply. I don't understand these masters.