Solar Heater For Pool - DIY Water Heater (3X) Triple Heating Power How To And Setup
ฝัง
- เผยแพร่เมื่อ 14 พ.ค. 2024
- Get hot water with this DIY solar heater for your pool build.
In this video, Im going to show you how I use an industrial heavy duty plastic pallet, irrigation tubing to built a solar heater that has triple the heating power for pools.
Check out this inexpensive irrigation tubing on Amazon:
amzn.to/3lDiExP
If you have been looking into how to make the best homemade solar pool heating systems, I hope this video can help.
I'm super excited because I've been looking at pool heater comparison and pool heater installation also read a bunch of solar pool heater review but they are all every complicated and expensive.
So today, I will be building this super simple water heater that could give 3X the heating power.
The entire build took me less and 2 hours, I absolutely think this is the best how to make solar pool heater video on youtube (my opinion =)
Zip Ties:
amzn.to/3lCjwTr
Check out my other videos on how to setup your above ground pool:
Bestway Pool Step by Step Setup:
• Bestway Pool Step by S...
Bestway Flowclear Pool Filter Setup:
• Bestway Flowclear Pool...
Thanks For Watching
Like and Subscribe to this channel for future videos - แนวปฏิบัติและการใช้ชีวิต
Should do a followup video seeing the difference in overall pool temperature. The pitcher was a good test case, but it'd be cool to see the entire pool temp difference as well. Thanks for sharing!
For sure I will try to get a video up but that was last year I haven’t even open my pool this year because of crazy California weather 😂
Enjoyed the video. Thanks for sharing
Thanks. And thanks for watching
Lovely video! I think the flow isn’t really that important since the heat is going to be put in the pool anyways. If you could build a glass box to go over your solar panel that would probably increase the heat by a few degrees since it wouldn’t allow it to escape.
I would also have all the hoses with the heated water submerged into the pool as the water contacting air while its falling cools it off.
Thank you. That’s a great suggestion I love. Thanks I will keep on trying to improve it 😀
Can you run the center pipe (inlet) under the palette? No shadow/shading on the coil.
🤯 I didn’t think about that, that’s a great suggestion 😀
Is there anyway to contact you directly