This issue can happen with the standard console Precor Console treadmills as well.. if you have a non touchscreen console, you can get into the maintenance mode by pressing CLEAR, 6, 5, ENTER at the homescreen.
Hi Ben, tried these steps, incline still doesn't work - do you know what it could be? My mover removed and put back during a move. Connections seems ok.
@kunalgandhi hi, try removing the lower circuit board (plastic box) then turn upside-down & unclip the flat plastic cover & you should see a round bergandi colour fuse (looks like the rubber on the end of a pencil, test with multimeter or replace & retest.
@@firmbutton6485yes. Ben is correct. Its the battery located either behind the frontmost cover of the machine, near the floor. Should be 4 screws holding the battery cover on. If this is an AMT or older model, this location may not apply. Be sure not to plug the battery wires incorrectly. That would be an expensive mistake
Greetings From Viña del Mar Chile
This issue can happen with the standard console Precor Console treadmills as well.. if you have a non touchscreen console, you can get into the maintenance mode by pressing CLEAR, 6, 5, ENTER at the homescreen.
Pause then 65 will get you into LED console maintenance mode
Hi Ben, tried these steps, incline still doesn't work - do you know what it could be? My mover removed and put back during a move. Connections seems ok.
@kunalgandhi hi, try removing the lower circuit board (plastic box) then turn upside-down & unclip the flat plastic cover & you should see a round bergandi colour fuse (looks like the rubber on the end of a pencil, test with multimeter or replace & retest.
I have the p80 on a elliptical cross trainer, the incline adjustment doesn’t seem to work. Any suggestions ?
Hi Mate, I would think it's the 12volt 5ah battery that is flat, just replace the battery & incline should work
@@BenHudspith where is the battery located mate? Mine is plugged in to the wall. Incline won’t budge from setting 2
@@firmbutton6485yes. Ben is correct. Its the battery located either behind the frontmost cover of the machine, near the floor. Should be 4 screws holding the battery cover on. If this is an AMT or older model, this location may not apply. Be sure not to plug the battery wires incorrectly. That would be an expensive mistake
Necesito ayuda con mi precor