Getting Started with the Emlid Reach RS2 | Remove known networks

This is a handy tip for configuring your RS2 once everything is set up and ready to go. By default, the Reach receiver saves wi-fi network credentials once you have entered them. Everytime you turn the receiver on it will connect to any known wi-fi networks that are visible.
If you prefer to have the receiver default to hotspot mode - even if you are near a known wi-fi hotspot, then you can remove the known network from the receiver settings.
Need help? This video will show you how!

[@shahayazkhan7308]

It's Gift for Ours surveying community. Sir we are very grateful. Its the most advanced and easy way to use the.

[@kulagabe]

This is the most important thing when you start out. It drove me nuts until we figured it out.

[@rolandoyepes8116]

Thank you, sir!

[@MangoesmappingAU]

Glad you found that helpful!

[@rolandoyepes8116]

@@MangoesmappingAU very much. I have also experienced that problem but when i see this content, i immediately follow the steps. No hassle.