How to Make LED Chip Welder Remover PTC Heating Soldering GA Station 220V 300W
ฝัง
- เผยแพร่เมื่อ 17 ก.ค. 2021
- How to Make LED Chip Welder Remover PTC Heating Soldering GA Station 220V 300W
Materials Required:
1. Aluminum Composite Sheet
2. 20mm Plywood
3. Aluminum Angle Bar
4. 220V 300W LED Remover PTC Heating Soldering Chip - bit.ly/3ex0WsZ
Specifications
Color: Silver
Power: 300W
Voltage: AC 220V
Material: Aluminum + PTC
Size: (L)X(W) 120x70mm / 4.72''x2.76''(appr.)
5. Corner Bracket 16mm x4Pcs - bit.ly/3z9ENIW
6. Power Cable 230V AC - bit.ly/3zbC41M
7. Heatshield Tape - bit.ly/36Gvjc2
Subscribe LahisTech: bit.ly/2JHtlyc
Subscribe for more future creative project videos.
Thank you.
#ledchipwelder #ptcheating - แนวปฏิบัติและการใช้ชีวิต
Hi love from India
Dil se baiya thanks
hello friend, how could I clean the plate from the encrustations that are created by welding the LEDs
Kahan se plete liye ho bhai
Cool
Hello.
Is this heater machine
Made in India?
Donde puedo consigir esta piesa nesecito ya
Super 👏
Super job
very useful device
Olá que fita é essa que vc colocou antes do termo retrátil?
Fita de alta temperatura (fita Kapton)
Mujhe chahie kaise milegi bolo Bhai
Y kha milega
What is the wattage of the heating element did you used tnx sir
300 W
Sorry but I have a couple of questions.
1. Can't you do it with a regular hot plate?
2. Why would you want to remove the LEDs in the first place?🤔
हर जगह कोनसा पार्ट मिलना है वह सच हैं गलतियाँ बधाई शुभकामनाएं भैया जान पैदा हुआ है जिवन रूपए देने बाद पुतिन चिन निती
sir if i want to heat nearly to 700 Centigrade is it possible with a small plate of around 5 *5 cm ?? please reply sir.....
This only gets to 200 °C
Hiiii
How many watts is it?
300 W
temperature how to control?
A PTC element will balance itself, because the resistance changes with the temperature. Usually about 260-270 degrees celsius. If a lower temperature is needed, there needs to be some kind of control loop using a sensor and a means of switching the PTC on and off.
This is dangerous! You need ground.
Neutral line is grounded from MCB.
@@LahisTechLTwhat about 2 red wires from hot plate,i dont know how to connect to the switch cable that have brown wire and blue wire..please help me
Hj
100 degrees is definitely not enough to remove the leds, it should be 400 degrees
That thing gets hot AF - His cheapo room temperature sensor is just rated up to 100°C. I can tell you it's gonna work! Just the missing PE (Protective Earth) makes me uncomfortable, so I suggest adding one by screwing it between the plate and one of the feet to prevent accidents!
LahisTech - on your youtube homepage it says that your location is Australia yet this electrical socket plug 7:25 is not for Australian electrical sockets, so why did you list your location as being Australia when you clearly don't live in Australia ?