Nice interference fit, thank you so much for your build videos, my 1m Dlg is almost finished :) My nose cone will be 3D- Printed. Weight should be fine too.
Very cool! Quick question: how many attempts did it take you until you got to this fiberglass R/E model? It flies amazingly well. How would you make ailerons for it, I mean how would you secure the moveable surface? I've been thinking about this if it's enough to leave one layer of fiberglass holding it or if it would be better to use some tape to secure it attached to the wing
I have build around 10gliders so far and all of them flew good enough straight away. For ailerons probably I would cut the top side leaving the bottom as a hinge and I would reinforce the hinge with some tape also from the bottom.
Very nice solutions! With these, You are bringing DLG flying closer to home builders again. 👍 Thank You!
greetings from Turkey
Hello my friend!
Nice interference fit, thank you so much for your build videos, my 1m Dlg is almost finished :) My nose cone will be 3D- Printed. Weight should be fine too.
Nice id like to see it fly!
Very cool! Quick question: how many attempts did it take you until you got to this fiberglass R/E model? It flies amazingly well. How would you make ailerons for it, I mean how would you secure the moveable surface? I've been thinking about this if it's enough to leave one layer of fiberglass holding it or if it would be better to use some tape to secure it attached to the wing
I have build around 10gliders so far and all of them flew good enough straight away. For ailerons probably I would cut the top side leaving the bottom as a hinge and I would reinforce the hinge with some tape also from the bottom.