ขนาดวิดีโอ: 1280 X 720853 X 480640 X 360
แสดงแผงควบคุมโปรแกรมเล่น
เล่นอัตโนมัติ
เล่นใหม่
would like to see that done with some nitronic 33. Always see aluminium at the shows and would like to see some super alloys sometimes.
Cipress 1337 You know this isn't Alu right?
How can you put out a video with your cutter chattering.Nice finish cut though
I tried it with my Widia end mill... and I broke my end mill... how much speed and feed rate have you programed?
It's shown on the screen.
Whats the spindle rpm?
It would be 14310 (450/10*318 = 14310)
Which type of vise this
With what software was this programmed?
SolidCAM iMachining
ale w imadło ktoś ładnie wjechał ....
Speeds and feeds are sooo off for that material. It's should never vibrate like that.
It doesn’t vibrate... the marks you can see are caused by the geometry of the tool... there is no vibrating or chattering and no, speeds and feeds are reasonable for tpc milling ;)
would like to see that done with some nitronic 33. Always see aluminium at the shows and would like to see some super alloys sometimes.
Cipress 1337 You know this isn't Alu right?
How can you put out a video with your cutter chattering.Nice finish cut though
I tried it with my Widia end mill... and I broke my end mill... how much speed and feed rate have you programed?
It's shown on the screen.
Whats the spindle rpm?
It would be 14310 (450/10*318 = 14310)
Which type of vise this
With what software was this programmed?
SolidCAM iMachining
ale w imadło ktoś ładnie wjechał ....
Speeds and feeds are sooo off for that material. It's should never vibrate like that.
It doesn’t vibrate... the marks you can see are caused by the geometry of the tool... there is no vibrating or chattering and no, speeds and feeds are reasonable for tpc milling ;)