I noticed that you connected the cable that comes out of the pump into the CPU_FAN header in your motherboard. I have read almost everywhere that it is supposed to go in your motherboard's AIO PUMP header always in order for the pump and water inside to go at full speed at all times. Please correct me if I am wrong. Thank you!
Hello. I recently took exactly the same one for 11900kf. This is just great cooling. You can't hear the pump at all. And a tdp of 200 watts cools at a pump speed of 2000-2100 and a fan speed of 1100-1200. But I don't use this mode. The maximum in games was 170-190 watts for a short time. At idle the processor is 40-45 degrees, under a load of 200 watts, it is around 80-85 degrees. And this is less than 50% of the operation of the liquid cooling system.
At 5:26 you messed up between [cpu_opt (you put wire cpu_fan)] and [cpu_fan (you put wire cpu_opt)] that explain why at 8:00 fan is 5000+RPM that is not fan, its pump (fan has 2000rpm) True?
One problem I see is all those cables. How do you manage to hide them inside the case? Was thinking of rotating 180° so the tubes sit on the left side, and that hides just about all the cables behind the board. Otherwise, I assume you had to unscrew the fans and rotate them so the wires were on the rear side of the radiator?
I don't understand 3:08. This piece isn't fitting into my motherboard (b650m pro rs) because the holes are close together. Is there anything i can do or is there something I'm doing wrong?
What am I missing here? Daisy chained all the fans and its a closed loop nothing left to plug in to the motherboard. Im also left with 2 cables from the pump that look like they need to be daisy chained as well but there is nothing left to connect them to 😵💫 Not to mention the SATA power cable. Like why the hell is did this product shipped with zero instructions?
Hello I recently bought this and I put it in my pc but the rgb for the fans are not turning on the rgb for the aio is turning on tho but not that fans and I followed all the steps correctly and I was wondering if I have to turn the rgb for the fans on manually on a software or something
I added the Thermalright CPU mount to replace Intel's crappy one that can possibly bend my I9-1200K. @3.18 you can see the CPU is held down on the sides two little tabs on each side. The force and the heat from that processor can bend that chip over time. So I replaced that CPU holder. Now I will see if their water cooler is up to Thermaltight's engineering standards of their CPU mount.
same case same frozen notte 360, why my frozen notte cables are between front glass and frozen notte fans and not as him? there is a way to move them to the other side?
@@mlion9148 sorry i forgot to answer you because the watercooling is directly connecting to your motherboard you can control the rgb directly on the software of your motherboard for my own it's asus armor
I currently have this in black. I'm thinking of installing a cpu contact frame and I don't want to remove the motherboard. Can I just put the screws for the cooler back on to hold the cpu back plate in place and remove/install the new contact frame?
Says so on the box. Mine just arrived. I was looking for an installer video for this exact cooler, so it's great that a video like this exists for an AIO noobie like me.
![ละลาย (LALALYE) - DAOU PITTAYA ต้าห์อู๋ พิทยา [OFFICIAL MV]](http://i.ytimg.com/vi/wo6r9TgausI/mqdefault.jpg)
I noticed that you connected the cable that comes out of the pump into the CPU_FAN header in your motherboard. I have read almost everywhere that it is supposed to go in your motherboard's AIO PUMP header always in order for the pump and water inside to go at full speed at all times. Please correct me if I am wrong. Thank you!
True but some motherboards dont have it
@@ZypherionRBX 👍
When your motherboard doesn't have the AIO PUMP header, then you're supposed to connect it to the CPU FAN header, dummy.
@@itcarecomputers isn't the pump the black_cable you fit in cpu_opt?
Hello. I recently took exactly the same one for 11900kf. This is just great cooling. You can't hear the pump at all. And a tdp of 200 watts cools at a pump speed of 2000-2100 and a fan speed of 1100-1200. But I don't use this mode. The maximum in games was 170-190 watts for a short time. At idle the processor is 40-45 degrees, under a load of 200 watts, it is around 80-85 degrees. And this is less than 50% of the operation of the liquid cooling system.
You think it can cool a i9 12900ks?
At 5:26 you messed up between [cpu_opt (you put wire cpu_fan)] and [cpu_fan (you put wire cpu_opt)] that explain why at 8:00 fan is 5000+RPM that is not fan, its pump (fan has 2000rpm)
True?
The log on the cpu block is slightly off centred for me, which is not good for my OCD :)
What did you do with the other ones that clip like the 4 pins I’m confused on it.
One problem I see is all those cables. How do you manage to hide them inside the case?
Was thinking of rotating 180° so the tubes sit on the left side, and that hides just about all the cables behind the board. Otherwise, I assume you had to unscrew the fans and rotate them so the wires were on the rear side of the radiator?
Yeah I did the same
Is the image in the air customisable?
Love the music with no explanation
What software did you use to customize the rgb
A loose SATA cable was included. must also be used ?
No
Its only if you dont have a free fan header
Edit : Spelling
That's so you can daisy chain rgb fans.
I don't understand 3:08. This piece isn't fitting into my motherboard (b650m pro rs) because the holes are close together. Is there anything i can do or is there something I'm doing wrong?
@@recentlyexecuted272 don’t need that for amd cpu read user manual and try
Hello, what exactly kind of additional fans did you buy to pair with thermalright frozen notte? Is TL-C12C-s X3 goods? Thank you so much!
Hello , how to change the color of the fans ? is there an app ?
I always have red do u know why?
what ram is that? I like the fact it lights up
@@TroyRossberg corsair vengeance DDR5
What am I missing here? Daisy chained all the fans and its a closed loop nothing left to plug in to the motherboard. Im also left with 2 cables from the pump that look like they need to be daisy chained as well but there is nothing left to connect them to 😵💫 Not to mention the SATA power cable. Like why the hell is did this product shipped with zero instructions?
Hello I recently bought this and I put it in my pc but the rgb for the fans are not turning on the rgb for the aio is turning on tho but not that fans and I followed all the steps correctly and I was wondering if I have to turn the rgb for the fans on manually on a software or something
Connect rgb 3pin cable properly that’s coming from fan
@@itcarecomputers I did and it’s connect to the rgb header
@@itcarecomputers I opened my pc up made sure all the cables were well connected turned it on and still no rgb on the aio fans
@@itcarecomputers but I am getting rgb on my other fans just not the aio one
@@abdulsubhan7232 then send it for warranty
My kraken 360 not showing proper image, it show image n gif in square? 🙁 how can I fix this ?😢
you need the ELITE for full screen. the non elite have the square small LCD.
Where do you buy the white version I can only find the black one online
From distributer in Middle East
Just bought mine on Amazon. 15 hours later, it's here.
Is there a page to control the lights of this cooler? I have the same one
Use your motherboard software
@@Ockyaf-_-would aura sync or rgb fusion work?
@@Ockyaf-_-nevermind I now just saw the aura sync on the box in the video
It looks so good and functions aswell 😍
what was the pc case in this?
I added the Thermalright CPU mount to replace Intel's crappy one that can possibly bend my I9-1200K. @3.18 you can see the CPU is held down on the sides two little tabs on each side. The force and the heat from that processor can bend that chip over time. So I replaced that CPU holder. Now I will see if their water cooler is up to Thermaltight's engineering standards of their CPU mount.
Looking for a 360mm AIO for my 12900k as well. What are your avg temps? I’ll be mostly gaming at 1440p
same case same frozen notte 360, why my frozen notte cables are between front glass and frozen notte fans and not as him? there is a way to move them to the other side?
unscrew the fans and turn them around so the fans and wires are facing where you want them to face.
Is the display customizable?
nope. Infinity mirror style with logo and ARGB.
i may have a stupid question
but how can we control the RGB of the frozen notte and also how can you control the ventilation of it ?
good question, I would like to know that too, have you found anything out yet?
i just got mine and have not put it on but you can try a program called "signalRGB" it can control all your rgb if the device is supported@@mlion9148
You use motherboard own software
@@mlion9148 sorry i forgot to answer you
because the watercooling is directly connecting to your motherboard you can control the rgb directly on the software of your motherboard for my own it's asus armor
@@alarmecolveryou mean asus aura sync?
Is this a Good Cooler for 14700K ??
Yes. I have it on mine and my idle temps are low 30's. Don't really game so I can't speak for that but it's quite.
@@cooldaddyslick6869 would you say the pump is quiet? I hate when aio pumps are noisy, and i want to get this one
How you changed RGB to steady bluish light @ 6:55 ?
rez
Do you find how he did it.
After half hour what are the remps ? & did U use a cpu bracket? Or anything special?
Cpu bracket comes with the cooler
theres no cpu opt in my motherboard what do i do?
I love how your video looks! how are you getting this camera effect?
Bro i am using iPhone for videos recording
@@itcarecomputers lmao the choppy frames are very fun to watch lol
@@100legobits i will upgrade soon don’t worry 😕
@@itcarecomputers It looks good through i really like it!
Anyone know if this will fit with ryzen 7 7800x3d ? It says am4 compatible not am5
AM4 and AM5 support
It’s compatible with AM5
Do u pay it?
I don’t see the and bracket
AMD
How can i activate the rgb‘s ? Did i Need to Download something ?
You can control with motherboard Rgb software
Is it push pull
i have only one place cpu fan1.. what to do
Love the music! Who is it?
what about noise?
Normal
I currently have this in black. I'm thinking of installing a cpu contact frame and I don't want to remove the motherboard. Can I just put the screws for the cooler back on to hold the cpu back plate in place and remove/install the new contact frame?
Yes you can but batter remove motherboard and install
Non capisco quali cavi hai usato nell'ultimo passaggio
Good for i5-14600k ?
Yes
NZXT doesn't show the real heat degree
It works with aura sysc?
Says so on the box. Mine just arrived. I was looking for an installer video for this exact cooler, so it's great that a video like this exists for an AIO noobie like me.
which case is it?
hey, did u figure out which case it is ?
i would say it is the nzxt h9 but that is not true because the feet under the case are wrong.
you can look to the phanteks xt view, thats a really nice case
Hiii, i have a question, how u can control the leds of the fans? like change the color, btw good vid
control via motherboard program
@@alekseyskurikhin5601 I already did it and it worked, thanks anyway
how can u switch the color of the fans pls someone help!
change the fan settings on your motherboard bios to pwm and you should be able to change the colour of the rgb from your motherboard.
I always have a red color do u now why?@SlickNick19
Cool, but what about AM5 for gamers?
My mainboard doesn’t have the g dy plug, can someone help me
Use the 5v one it’s the same thing cause it’s for the fans
Music name ?
How do I change the color on it?
Same question 😅
@@diegozx5810There should be a led button on your pc case near the power button
Thanks man
Always welcome bro
My cooler is always red and I can't change it even though I've tried many times. @@itcarecomputers
trop bien bb
😍😍
Case
Not nearly enough thermal paste.
为什么我的灯光一直不亮？
How do I change the rgb color?
you need to download the software from your specific motherboard brand