No Penetration (Part 3) Metal Roof Solar Panel Install is Making Power!

แชร์
ฝัง
  • เผยแพร่เมื่อ 24 ธ.ค. 2024

ความคิดเห็น • 49

  • @JohnSolar283
    @JohnSolar283 9 ปีที่แล้ว +1

    Very nice Norm love that folks can see a small system works.

    • @NormanMcGregor
      @NormanMcGregor  9 ปีที่แล้ว

      +John Solar 283 ™ Yes John! Solar can be affordable for most anyone's needs if sized correctly!

  • @jwsolarusa
    @jwsolarusa 9 ปีที่แล้ว +2

    You did awesome job Norman.
    You got some beefy wires on those batteries.
    This is a one in town Solar backup System.
    I love your setup nice and simple.
    Just a quick advice for you. Make sure you have those batteries off the ground because batteries don't get along with concrete cement.
    Please post more videos as you rap up your installation.
    God bless you and your family.

    • @NormanMcGregor
      @NormanMcGregor  9 ปีที่แล้ว

      +JWSolar uSa Thanks John! The battery cables are 4.0, nice and beefy for sure. The batteries are sitting on a wood frame about an inch and a half above the floor. Provides for good cooling of the batteries. Looking to add in a grid tie inverter like yours. How do you like it??

    • @jwsolarusa
      @jwsolarusa 9 ปีที่แล้ว +1

      It's ok.
      Make sure you buy the 20Vdc - 60Vdc since your battery bank is 20Vdc
      I only use it for backup especially for winter here in Minnesota.

    • @NormanMcGregor
      @NormanMcGregor  9 ปีที่แล้ว +1

      JWSolar uSa How do you have it hooked up? Solar panels or battery bank? My panels put out 85VDC which are too much for the 20-60VDC model. :(

    • @jwsolarusa
      @jwsolarusa 9 ปีที่แล้ว

      According to your, i suppose you have 250W Solar Modules which is are 24V modules right?

    • @jwsolarusa
      @jwsolarusa 9 ปีที่แล้ว

      I heard you said you got them wired them in two strings of three right?

  • @KVUSMC-KU4SMC
    @KVUSMC-KU4SMC 9 ปีที่แล้ว +1

    First Class Install Norman Love The Set Up Buddy

    • @NormanMcGregor
      @NormanMcGregor  9 ปีที่แล้ว +1

      +KVUSMC / Kenneth W Viar Jr its simple and effective for sure Kenny!! Thanks Buddy!! :)

    • @KVUSMC-KU4SMC
      @KVUSMC-KU4SMC 9 ปีที่แล้ว +1

      Simple Is Good And Reliable Nice Equipment And Install

    • @NormanMcGregor
      @NormanMcGregor  9 ปีที่แล้ว +1

      +KVUSMC / Kenneth W Viar Jr Thanks Buddy! :)

    • @KVUSMC-KU4SMC
      @KVUSMC-KU4SMC 9 ปีที่แล้ว

      Norman McGregor Your Welcome Buddy

  • @JustinCaseSolarPower
    @JustinCaseSolarPower 9 ปีที่แล้ว +1

    nice system. that combined with your generator is all you need out there :). everybody Shoud be doing this. very cost effective system Norm.,

    • @NormanMcGregor
      @NormanMcGregor  9 ปีที่แล้ว +1

      +Justin Case Yes Chris! Its a good backup system to start with here and my propane generator will make up any deficiency in power this Winter but I will be adding much more to the system as time goes on.

  • @gyoung7332
    @gyoung7332 9 ปีที่แล้ว +1

    Any reason you did not raise the panels a few inches off the roof? Would give better air circulation to cool the panels.

    • @NormanMcGregor
      @NormanMcGregor  9 ปีที่แล้ว +1

      +G Young The panels are 2.5 inches off the roof. More than adequate for retaliation here and low enough for the high wind conditions we experience. A Very Nice Balance!!

  • @MrPlayfulOtter
    @MrPlayfulOtter 9 ปีที่แล้ว +1

    Nice job Norm! What type of panels did you put up?

    • @NormanMcGregor
      @NormanMcGregor  9 ปีที่แล้ว +1

      +MrPlayfulOtter The panels are made in Burnaby, BC Canada by DayFour! I Love North American made products! :)

  • @Redlinesixtynine
    @Redlinesixtynine ปีที่แล้ว

    I'm new to the solar panel thing, other than a small one used to trickle charge my fencer battery. So we want to install a small 100 watt panel to a small cabin we have. I have the panel, I have a 30 amp controller here, and now I see you have a shunt in the circuit. Would I need one on a smaller set up like this? Thanks.

    • @NormanMcGregor
      @NormanMcGregor  ปีที่แล้ว +1

      The shunt measures the solar power going in to the battery and also the power being pulled out of the battery by the inverter so the controller can provide information about charge level and state of charge. In a smaller system this is not needed.

    • @Redlinesixtynine
      @Redlinesixtynine ปีที่แล้ว

      @@NormanMcGregor Appreciate the speedy reply!

  • @CHICKENRELIGIONCOM
    @CHICKENRELIGIONCOM 9 ปีที่แล้ว +1

    having thatuch power in solar,how many more of those batteries, could you add to take more load off of the controller

    • @NormanMcGregor
      @NormanMcGregor  9 ปีที่แล้ว

      The amount of solar panels are balanced with the batteries to provide maximum power storage. The Xantrex controller can easily handle this and supply enough power to run quite a bit more while still charging the batteries.

  • @buzzsah
    @buzzsah 9 ปีที่แล้ว +1

    How many watts are you running?

    • @NormanMcGregor
      @NormanMcGregor  9 ปีที่แล้ว +1

      +buzzsah The system consists of 1.4kw of solar panels, a 4kw inverter and a 390ah battery bank. Should run my fridge, freezer, TV and lights in a power outage for 2 days without a sunny day and more with sunny days.

  • @CHICKENRELIGIONCOM
    @CHICKENRELIGIONCOM 9 ปีที่แล้ว +1

    did I hear you correctly say that each one of those batteries has 390 amp, Wow

    • @NormanMcGregor
      @NormanMcGregor  9 ปีที่แล้ว

      +CHICKENRELIGION.COM Yes each of the batteries are 390AH @ 6VDC. The 4 batteries are wired in Series to provide one 390AH @ 24VDC battery bank.

  • @shantaymadison5581
    @shantaymadison5581 8 ปีที่แล้ว

    You should go to Inplix if you'd like to make it by yourselfs guys.

  • @JohnSolar283
    @JohnSolar283 9 ปีที่แล้ว +1

    And that will be first again.