Westerbeke 7 5 MCGA Shuts down with Speed code

Hello Guy's, today I diagnose a westerbeke that continually shuts down for the owner, and the steps I took to fix it. Need help with your westerbeke or other generator in the Southern California Area, Give us a call at 1(949) 922-4180

[@AchikSarih]

Thank you, my brother, for this distinguished work. I salute you, my brother❤❤❤❤❤

[@AchikSarih]

Thank you very much, my brother, for this distinguished and good work. May God reward you for it. You provide something special that we can benefit from. Thank you very much.❤❤❤❤❤

[@AdventuresofHappyOurs]

My 3.5 Westerbeke is giving me a “check engine” code on the controller and it won’t start until I reset the 12volt breaker on the controller. It then runs fine. I’m thinking bad k1 relay?

[@SJCompleteMarine]

If you have a static check engine light, then that means the engine has a static code, either a sensor or emissions problem. on 3.5's it can be a lot of different sensors, usually throttle body, intake temp or coolant temp sensors

[@AdventuresofHappyOurs]

Why would it send an over speed code on a low oil pressure sensor problem? 😊

[@SJCompleteMarine]

The engine could not move the throttle body well, it was sticky. I also cleaned the throttle body and that helped show the symptoms I was experiencing. The fuel pump is actuated with a 20 second time delay relay activated by oil pressure, but once the 20 seconds were up, it shut the fuel pumps off.

[@AchikSarih]

❤❤❤❤❤❤❤❤