Hi Bruce, so I cleaned and adjusted the pins on both ends of my phono wire harness but still get distorted sound. When I tap or move the plug on the Amp end it causes the sound to fluctuate in and out of clear to distorted. I've replaced the fuses and transistors on the Amp as well as changed out the needle. Checked all tonearm wires, Pulled off the circuit board on the amp and checked the pins, everything seems fine, I'm at a loss....oh and I've also replaced the potentiometer as the volume control was real touchy when I got this jukebox. It's an Ami Rowe R-93
I have a few connector pins that are broken.. The example is the last one shown & seen in the drawing. Where can I purchase these and what are they called. Many thanks for your videos. They're very helpful.
THANK YOU FOR THIS VIDEO!!! I just spent hours trying to figure out the ribbon cable header.
Thank you very much sir for doing this video. You helped tremendously.
Hi Bruce, so I cleaned and adjusted the pins on both ends of my phono wire harness but still get distorted sound. When I tap or move the plug on the Amp end it causes the sound to fluctuate in and out of clear to distorted. I've replaced the fuses and transistors on the Amp as well as changed out the needle. Checked all tonearm wires, Pulled off the circuit board on the amp and checked the pins, everything seems fine, I'm at a loss....oh and I've also replaced the potentiometer as the volume control was real touchy when I got this jukebox. It's an Ami Rowe R-93
Helpful video thanks.
I have a few connector pins that are broken.. The example is the last one shown & seen in the drawing. Where can I purchase these and what are they called.
Many thanks for your videos. They're very helpful.
This is amazing, thank you so much!
what size pin extractor do you use?
Hopefully you respond. What specifically are those connectors called so I can order one for my Rowe model R88. Thanks
Molex