For those without an impact trying to remove the sway bar linkage: Use a wire brush and rust penetrant as shown. Then, insert an Allen wrench into the hex-shaped opening and put a wrench on the nut. Loosen the nut and gently turn as far as possible. If it starts binding, tighten the nut back down and spray again with penetrant. Let it sit a minute and then loosen again. You should be able to go a little further. Repeat the process. I was able to remove all my sway bar end links this way without any hassle. Just be patient.
Dude your great video is making me.want to own the strut replacement on wifes 15 mdx sh awd. Pretty sure.both a leaking with about 150k on them. Thanks man rightbto the point.no wasted time. Batta boom👍👍👍👍
Yeah defiantly a good DIY buy conplet assembly’s KYB is good brand. And if ur truck got the sensor shocks u gonna have to get them from dealer lotta people put regular one and then u have all the lights on dash
Looking for torque specs for 2018 Acura RDX front strut 2 pinch bolts go through knuckle and the single top strut bolt that goes through the center of the coil spring since I reused the factory coil spring? Thanks!!
Sir my mechanic tried to change the strut for me but he couldn’t get it out and he told me i might need new control arms because for some reason when he force the strut out i will need a new control arm taking in consideration it is all new control arms installed few weeks ago is there any other way to do it
I replaced my struts about 3 weeks ago and I get this binding sound from the drivers side when I make a sharp left turn; then the car pulls hard left until I make a sharp right turn; then it straightens out. I was told the struts need to settle in place, but after a few hundred miles I would think they would be settled. Do I have a bad strut(s)?
My car has a noise on the driver side i hear it while driving and going on bumpy roads but only on front left could be this? Where are you located i have bad luck with mechanics?
@@RBTheMechanic thanks for the reply. I just bought both strut quick strut. The box came broken and when I look at the strut the upper side where the 5x bolt goes is tilted to one side. it looks like it tilts more towards the long screw. Is this normal?
Great video my friend. I replaced my struts on my 2007 MDX but have the ADS light on the dash. Is there a resistor I can use to bypass this so the light doesnt come on? Im not concerned about sport/comfort as the vehicle is older now but still works great. What Ohm resistor can I use. Acura wont sell them to me. ugh thanks Rick
@RB The Mechanic thanks for your text. Sorry I meant I need a resistor because I went from electronic to base struts w/o connections for electronic comfort/sport. Now the ads light on the dash shows up because I need to fool the connection that I have a connection when I don't. Hard to find these resistors. Any idea how many ohms resistor I need ? There are some on Amazon but not sure which would work. Acura wont tell me ... thanks
@@RBTheMechanic my friend replaced about a month ago used 7 Ohm resistors (he told me will work any from 7-14 Ohm). works good as for now. im also gonna be replacing in couple weeks
No shouldn’t have affect only if I removed and disturbed the threads on tie rods it would have been crital but however I should get alignment since we have changed struts things will be diffrent In height and small change due to the strut bolts on spindle
Dooode !!! Great video. This is the only vehicle i cant find replacement videos on ahahhaa. Question ! I have a 2013 with 100,000 miles. Feeling like I'm due for a change soon. These will work on the 2013 technology package trim right ?
@@RBTheMechanic thanks for the reply and do the struts you used maintain the SH-AWD feedback or what ever the OEM shocks do in terms of compatibility? Thanks in advance!
@@ZiggyGood it dose it shows some light if u put on struts without sensor some of these have sensord shocks struts people use regular these struts. If it’s are equipped with those u have to put those in which are like $700 a strut
Wonderful. Figured it was an easy job. Just needed to see it done to be sure. Saves hundreds of dollars
Yup
For those without an impact trying to remove the sway bar linkage: Use a wire brush and rust penetrant as shown. Then, insert an Allen wrench into the hex-shaped opening and put a wrench on the nut. Loosen the nut and gently turn as far as possible. If it starts binding, tighten the nut back down and spray again with penetrant. Let it sit a minute and then loosen again. You should be able to go a little further. Repeat the process. I was able to remove all my sway bar end links this way without any hassle. Just be patient.
Oh yeah I have other videos showing that way… nice tips!!
Dude your great video is making me.want to own the strut replacement on wifes 15 mdx sh awd. Pretty sure.both a leaking with about 150k on them. Thanks man rightbto the point.no wasted time. Batta boom👍👍👍👍
Yeah defiantly a good DIY buy conplet assembly’s KYB is good brand. And if ur truck got the sensor shocks u gonna have to get them from dealer lotta people put regular one and then u have all the lights on dash
Well done. Doing mine this week. Thank you!
Very nice job explaining the procedure.
Thank you!
Monroes website doesn't show any structs for the 2014 MDX, what part dis you use?
I show in the video
Great job explaining this!!
You looks professional shows in detail
Thank u
How did it ride with Monroe’s? Just ordered a pair, hoping I shouldn’t have went with KYB??
It was good been good
Do the struts come with the upper bearing/bushing? I mean the one under the upper mounting plate.
If u buy the assembly it’s all a pack. But not struts alone
Looking for torque specs for 2018 Acura RDX front strut 2 pinch bolts go through knuckle and the single top strut bolt that goes through the center of the coil spring since I reused the factory coil spring? Thanks!!
Sorry I don’t have the information subscription for data charges for acess
Excellent tutorial
Yup thank you! This will help lot of people
Where the conversion kit those who have sports/comfort suspension?? How does that work? I’ll just have the light in the dash right?
Yeah u will have all the lights on dash don’t by pass it do it propperly my friend did that it not same truck anymore
thank you brotha im about to do this now
Welcome
I didn’t see you plug the shock sensor ?! I ordered after market shocks they didn’t come with the plug port for the sensors like the oem shocks
This is not equiped with that type of ride comfortably
Sir my mechanic tried to change the strut for me but he couldn’t get it out and he told me i might need new control arms because for some reason when he force the strut out i will need a new control arm taking in consideration it is all new control arms installed few weeks ago is there any other way to do it
He’s crazy try another repair shop
I replaced my struts about 3 weeks ago and I get this binding sound from the drivers side when I make a sharp left turn; then the car pulls hard left until I make a sharp right turn; then it straightens out. I was told the struts need to settle in place, but after a few hundred miles I would think they would be settled. Do I have a bad strut(s)?
I don’t think it’s bad strut double check ur work and then it could be strut was installed wrong top base did u buy complet assembly or
Just the strut
@@RBTheMechanic They were complete assemblies. I don't see where anything is wrong.
@@jflattum the top strut mount could be off I had sienna that rubbed and grinded on turns it was mounted wrong check for any rubs and scraches
@@jflattum check for issues one one side and just replace it if u still got warranty
My car has a noise on the driver side i hear it while driving and going on bumpy roads but only on front left could be this? Where are you located i have bad luck with mechanics?
I’m in north NJ Bayonne area ru local? It could be links or and bushing before struts check those
Good work and great video!
Nice video.. got aome question which one is the right side? Passenger or driver. And if i replace one do i need to replace the other side?
Passenger side is the right side yes if u replace one do replace the other side
@@RBTheMechanic thanks for the reply. I just bought both strut quick strut. The box came broken and when I look at the strut the upper side where the 5x bolt goes is tilted to one side. it looks like it tilts more towards the long screw. Is this normal?
@@kenc6602 or understanding what u mean make a video clip
Great video. Helps a lot, thank you! :)
Glad it helped!
What’s the link to buy those
Sorry I don’t have the link I got them from my local part store but u can search by part number I show
Great video my friend. I replaced my struts on my 2007 MDX but have the ADS light on the dash. Is there a resistor I can use to bypass this so the light doesnt come on? Im not concerned about sport/comfort as the vehicle is older now but still works great. What Ohm resistor can I use. Acura wont sell them to me. ugh thanks Rick
No resistor but u got the old shocks u can pull out the sensor
@RB The Mechanic thanks for your text. Sorry I meant I need a resistor because I went from electronic to base struts w/o connections for electronic comfort/sport. Now the ads light on the dash shows up because I need to fool the connection that I have a connection when I don't. Hard to find these resistors. Any idea how many ohms resistor I need ? There are some on Amazon but not sure which would work. Acura wont tell me ... thanks
@@siwagi not sure bro if u do figure somthing out let me know I got a guy with same issue
Okay thanks I will let you know cheers.
@@RBTheMechanic my friend replaced about a month ago used 7 Ohm resistors (he told me will work any from 7-14 Ohm). works good as for now. im also gonna be replacing in couple weeks
Good video buddy. Are this Monroe struts any good as the oem?
Yeah they are solid I never had issues just don’t buy the $115 cheap ones
How much would this cost at a shop? Might try and tackle this myself when the time comes.
Oh boy Lott they might charge u $1400 best do it urself and buy some good prts
where did you get the damper and how much did you pay for the damper?

where did you get the damper and how much did you pay for the damper?
I bought the struts as complet assembly from my local partnstore
Is that the one with damper sensor? Do you need to re-program it if that will be the case?
No this dosent have the sensors I did the ones with sensor before u don’t need to program them
Thank you. I just need to find your video, the one with damper system for mdx. Do you still have the link? Thank you again.
@@louiebasilio5496 I don’t have video on it I didn’t have the channel when I did those
@@RBTheMechanic So, any differences removing strut with damper sensor from without? Or is it more complicated? Thank you.
@@louiebasilio5496 nope it’s same thing just extra component but the new models have diffrent base with bore in spindle which is very complicated
Where is your shop located?
I want to take my 2009 MDX to you. I need a tune up and front struts replace
I’m up north nj Ru local to Bayonne area?
I cant find the strut Assembly anywhere
Try buywise auto in nj
Thanks for the video! Have you affect alignement?
No shouldn’t have affect only if I removed and disturbed the threads on tie rods it would have been crital but however I should get alignment since we have changed struts things will be diffrent In height and small change due to the strut bolts on spindle
@@RBTheMechanic thanks
Dooode !!! Great video. This is the only vehicle i cant find replacement videos on ahahhaa.
Question !
I have a 2013 with 100,000 miles. Feeling like I'm due for a change soon. These will work on the 2013 technology package trim right ?
Some are some not so make sure u find out for parts department but I think they r same
Great video thanks
What year model is this
2012 no electric suspension
Hi if one strut is bad do you have to change both struts or were both your struts bad. And awesome vid you made it look too easy!
To make it even u should replace both. And yes on this car I did both cuz they both were equally bad
@@RBTheMechanic thanks for the reply and do the struts you used maintain the SH-AWD feedback or what ever the OEM shocks do in terms of compatibility? Thanks in advance!
@@iamnucleus no this dosent have the option u need the $800 struts lol
@@RBTheMechanicwait what?! The AWD doesn’t work when you put these on?
@@ZiggyGood it dose it shows some light if u put on struts without sensor some of these have sensord shocks struts people use regular these struts. If it’s are equipped with those u have to put those in which are like $700 a strut
Gd teaching
Yup!!
Great vide thanks
Replacing the vehicle's shock absorber reports an error
What u mean
Are these electronic struts??
No this mdx not equipped with those
I have a question my 2012 Acura MDX come with some wires were the struts are.. What type of struts will I need??
@@lashandramays3223 those are special expensive struts I don’t know the name but if u call parts department they can tell u
Bueno
Thank you
I prefer KYBs over Monroe.
Me too kyb I used them lot back in days