Good video. Did same job recently with same outcome on fan pressure, at -4.5mbar, plus some minor adjustments on gas valve. Interested in how you tested seal integrity, can you say more about the sensor. Thanks again, look forward to next video.
Hello. I recently gave a full service to Worcester CDI. Cleaned heat cell, new electrodes installed, new baring plate and all seals installed. Max and min readings perfect. But fan pressure and gas rate is still less than they should be. What else could be causing these low readings?
I’m in the middle of a job exactly the same. Replaced all seals and bearing plate. Heat cell was quite clean. Now the fan pressure is worse😢. I have just ordered a new fan. I know it’s 3yrs ago, but did the new fan sort it?
Good video. Did same job recently with same outcome on fan pressure, at -4.5mbar, plus some minor adjustments on gas valve. Interested in how you tested seal integrity, can you say more about the sensor. Thanks again, look forward to next video.
Adam Carter use a small mirror, if it steams up the seal has gone
I’m having quite a few low fan pressures due to a lazy fan. Tends to be more on the cdi’s too
great video from worcester legends
Great video mate, thanks for sharing with us. 5⭐⭐⭐⭐⭐
U9 fault on green star 532i. On ch/hw. Takes 25 mins to get to 82 deg Cleaned heat exchanger
Hi got poor negative fan presure, just done full service.
Blown though test point and I know manometer OK.
Any pointers on negative can cause this
Class video bud!
You are superstar
Brilliant
What was the probe you used to check seal integrity? Thanks
It's an Anton Ng sniffer, if you haven't already figured it out.
franco porco f&
Hello. I recently gave a full service to Worcester CDI. Cleaned heat cell, new electrodes installed, new baring plate and all seals installed. Max and min readings perfect. But fan pressure and gas rate is still less than they should be. What else could be causing these low readings?
Faulty fan not running as fast as it should be.
@@johnabiodun5540 Thank you. I’ll look into that 👍🏽
th-cam.com/video/GiRo01XDd5M/w-d-xo.html
In this video he shows how to check the bearing plate and adjust the fan speed. Maybe try that 1st 👍🏽
I’m in the middle of a job exactly the same. Replaced all seals and bearing plate. Heat cell was quite clean. Now the fan pressure is worse😢. I have just ordered a new fan. I know it’s 3yrs ago, but did the new fan sort it?
What fault made you check the fan pressure?
Fan pressure should always be checked irrespective of faults 👍
What tool you using to clean heat ex?
BrosnanEvans it's the cdi cleaning kit. There's a part number for the kit in the back of the MIs or look for it on internet