For me helped hand brake reset. Just hold hand brake button for 5 seconds up, thant 5 s down. It was changed from manual to automatic hand brake release.
i am doing it tomorrow too,.. using used epb unit. read eeprom st 95160 from my original car and copy files to the new used epb unit,.. i hope this will work the housing can be opened with constant heat and pressure. the RTV gets soft and the lid can be removed.
I manage to get the connector of the unit, but how do you manage to get cables of the straps? Everything is so hidden between fuel tank, beam, and spare tire well. Was the bad connection near the connector or somewhere else?
@@86msv Mine was just before the connector. Open connector and first part of harness, if the same as mine. Didn’t take anything exept for the connector. Hope it helps.
I just that problem today . Took the battery out for one hour and . Torn on the car after putting the battery back but not the engine and turn of take out the key then start the engine.all was good 👍. Almost spet shit lode of money on this shit .😅
Hey man. I have the same warning on the dash. The warning appeared after changing one caliper on the rear left. Apperantly the caliper seems fine and toyota said they checked everything(i don't believe them), but they say i need to change the actuator for almost 4k euros. This can't be. so in order to use a second hand unit you have to change over the chips?
Zinok nesu expertas su sia toyota tai nezinau tikslaus atsakymo, siaip jei labai reikia imi turbinke pjauni trosa, ir po to jau rankinio nelieti nes suvels ten viska vidui
@Dinamikass just managed to change the acuator, but now its Says check parking brake system, and only release the hand brake but don't lock hand brake? Tried with snap on computer and still no luck?
@@Dinamikass turiu irgi panasia problema diagnostika parode veikiantis stabdziai rankinis . issiaisinau suportai ne duoda nulines asies .spiruokle ne duoda grizti i nuline pozicija .del to (1511.63lb-ft)
you can take holiday trip to lithuania in klaipeda city , and i can fix your eprom :) or send both modules but its difficult now brexit customs .... try to find local cybernetic man :)
I have tried every diagnostic company near me and nobody can do it. Does the EPROM have to be swapped with replacement unit? It works for a few days after code removed but comes back C13ab Tension sensor malfunction.
First a have got used one, moved eprom from old to to this used. Installed to car but it comes this errors, finaly i found that i was not closed enough cover, and sliders inside cannot slide smoothly. So i pressed like it must and its start working.
I'm from Greece, I have a Toyota Avensis touring sports 2016 1.6 diesel, can someone please tell me how to change the antifreeze, apart from the screw in the radiator, is there another screw in the motor that I have to remove in order to drain all the fluids?
@@Dinamikassthank you very much my friend. I am asking why in older models there was also a drain screw in addition to the radiator and on the body of the machine.
For me helped hand brake reset. Just hold hand brake button for 5 seconds up, thant 5 s down. It was changed from manual to automatic hand brake release.
i am doing it tomorrow too,.. using used epb unit. read eeprom st 95160 from my original car and copy files to the new used epb unit,.. i hope this will work
the housing can be opened with constant heat and pressure. the RTV gets soft and the lid can be removed.
yes it will work
@@Dinamikass Did work great!
@@Dinamikass without soldering :D
@@dantical4654 nice
My Avensis has a C13A5 error. Do you know where to look for the cause? I'm from Poland. Thanks for your help
Helo, can you write full fault code with explain
emergency release cable. I don’t remember, but there is a limiter (600 revolutions)
Had same issue. Black wire to cluster in EPB multi connector was broken.
I manage to get the connector of the unit, but how do you manage to get cables of the straps? Everything is so hidden between fuel tank, beam, and spare tire well. Was the bad connection near the connector or somewhere else?
@@86msv Mine was just before the connector. Open connector and first part of harness, if the same as mine. Didn’t take anything exept for the connector. Hope it helps.
I just that problem today . Took the battery out for one hour and . Torn on the car after putting the battery back but not the engine and turn of take out the key then start the engine.all was good 👍. Almost spet shit lode of money on this shit .😅
Hey man. I have the same warning on the dash. The warning appeared after changing one caliper on the rear left. Apperantly the caliper seems fine and toyota said they checked everything(i don't believe them), but they say i need to change the actuator for almost 4k euros. This can't be. so in order to use a second hand unit you have to change over the chips?
Yes you must move chip info
@@Dinamikass i hope someone can do it in Norway. if not i'll have to come meet you in Lithuania to save my Avensis x)
@@martinrugas9542 where holding you in norway ? oslo ? Jeg kjenner flere som kan hjelpe deg med den chip flyyting.
@@Dinamikass Wow. jeg er ikke i Oslo for øyeblikket, men jeg skal til Oslo om ikke så veldig lenge. jeg er interessert i det ja,
@@martinrugas9542 skriv meg pa whatsaap eller viber +37064148008 jeg gi deg tips hvor du kan ringe
ka daryt jei sugenda rankinis? ir neina atleist , o reik pajudet i vietos? rankiniu avariniu budu galima tai padaryt?
Zinok nesu expertas su sia toyota tai nezinau tikslaus atsakymo, siaip jei labai reikia imi turbinke pjauni trosa, ir po to jau rankinio nelieti nes suvels ten viska vidui
aciu labai
👍
I have same problem with my car many time this text come on screan check parking brake system and with warring flash
What software are you using?
launch, and autocom
Sveikas gal isiaiskinai beda, pasidalinsi info ?
Labas, Problema buvo kad buvo nedaspaustas korpusas. Neuzdarytas iki galo
is 2010 and 2012 avensis have same electric handbrake?
Sory dont know
How did you take out the actuator? I need to replace mine?
Car owner took out actuator, i did electric job .
@Dinamikass just managed to change the acuator, but now its Says check parking brake system, and only release the hand brake but don't lock hand brake? Tried with snap on computer and still no luck?
what fault codes you have in epb
@@alejaz8403
@@Dinamikass just says mismatch... not clear on snap-on
@@Dinamikass where u from mate?
Did you find a fix for the issue
Yes, i pressed more together frame, that sensor see position. And all started to work good. It was opened to write eprom, and not closed good enough.
@@Dinamikasswhat did you do? Kak ubral oshibku? Aciu
@@alext-v8788 pushed more togeteher box, was not closed enaugh
Ok. I'll check the actuator. Thank you
Ar pavyko suremontuoti?
Atstobybėj kiek girdėjau apie 1200e bloko keitimas.
Taip pavyko, veikia puikiausiai
hello can you give me instructions on how to remove the electric handbrake please?
Sory my mechanic have taket it out,i just check electrics problems
@@Dinamikass turiu irgi panasia problema diagnostika parode veikiantis stabdziai rankinis . issiaisinau suportai ne duoda nulines asies .spiruokle ne duoda grizti i nuline pozicija .del to (1511.63lb-ft)
veikiantis parametrai (1511.63-ft) dirbba
radau problemma support silpna spyruokle grizymo atgal rankynio(((( gal tame?)
not not relaise TA not confirm((((((
What is your obd?
Autocom
Turiu panašią problemą. Kokiame mieste esate?
klaipeda
I have a problem with mine, I want to use a second hand unit but cannot find anyone that can swap EPROM.
you can take holiday trip to lithuania in klaipeda city , and i can fix your eprom :) or send both modules but its difficult now brexit customs .... try to find local cybernetic man :)
I have tried every diagnostic company near me and nobody can do it.
Does the EPROM have to be swapped with replacement unit?
It works for a few days after code removed but comes back C13ab
Tension sensor malfunction.
@@steveselvage40 c13ab i google it and it says parking brake switch ? Maybe you have faulty switch buttom ?
Take battery out for 1 hour and it will work OK pall
Kaip pavyko sutaisyti?
pavyko, sunkiai bet problema buvo tame jog korpusa reikejo tvirciau suspaust , nes buvo ardytas ir nesusipaudes kaip turi buti
@@Dinamikass gal galeciau paskambinti del sio gedimo? Numerouka savo jei duotum. Aciu
Get some problem in my 2015 busienss edition toyota avensis please advise me thanx
Look some lokal car repair shop
How did u fix it?
First a have got used one, moved eprom from old to to this used. Installed to car but it comes this errors, finaly i found that i was not closed enough cover, and sliders inside cannot slide smoothly. So i pressed like it must and its start working.
@@Dinamikass you mean you changed TOYOTA PARKING BRAKE ACTUATOR? The black box and lines?
@@tonyali7388 yes black box and the lines, but after i changed its still was not working
Why can't the circuit board be prepared...???
Repaired
I'm from Greece, I have a Toyota Avensis touring sports 2016 1.6 diesel, can someone please tell me how to change the antifreeze, apart from the screw in the radiator, is there another screw in the motor that I have to remove in order to drain all the fluids?
I think there is no special drain screw. Take out hoses and use compresed air to push out all antifreeeze
@@Dinamikassthank you very much my friend. I am asking why in older models there was also a drain screw in addition to the radiator and on the body of the machine.
older models was more quality , or i dont know :) @@karl-heinzrummenigge6605